To allow the engine to slow the vehicle rather than put wear on the hydraulic brakes.
Yes you can
You really don't need it. You just need to identify which harness goes from the ECM to the jake brake.
a Jake Brake
You can run the overhead, on your Caterpillar 3176 diesel engine with a Jake brake, by removing the Jake brake. Next, remove the valve cover. Adjust the overhead with the adjustment screws.
buy a Jake brake kit from banks or something
Yes you can. There are 3 places on the passengers side of the valve cover (1 for each head) where the jake brake wire plugs in. If you unplug each of those wires, you will disable the jake brake.
the Jake brake and similar brakes redirects the engines exhaust, using the resulting compression to slow the cylinders of the engine which cuts the rpm dtrastically, therefore slowing the vehicle.
no, he is working on her new movie
Are you talking about the Jake Brake on semis?
Mine did. Not completely shut down, but would make no more than 25 mph with the pedal on the floor. Turns out the butterfly valve of the "Jake brake" was sticking. Turn off the Jake brake and the problem goes away.
to truck drivers to hit the Jake brake is to pull on a handle on t he sterring column and shut down the engine
You're talking about an engine compression brake, commonly referred to as a Jake Brake.