answersLogoWhite

0


Best Answer

throw out bearing is bad. pull trans and replace. you can spray bearing with wd 40 and noise will stop for a few minutes. it may have caused dammage to the pressure plate. replace all three.

User Avatar

Wiki User

โˆ™ 2006-04-14 03:05:22
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Why would you hear a grinding noise when the clutch is depressed even when in neutral on a 1996 Mazda B3000?
Write your answer...
Submit
Related questions

Mazda b3000 clutch working in upper gears but not to lower gears or reverse?

get a new clutch


Is the 1996 Mazda B3000 hydraulic clutch self adjusting?

No this clutch needs to be bench bled prior to instalation.


Where is the clutch fluid reservoir on a Mazda B3000 truck?

look on the drivers side firewall


I need a diagram to replace the clutch in a 1994 Mazda b3000?

A diagram to replace the clutch in a 1994 Mazda B3000 is available in how-to books at most major auto parts stores. These types of manuals are also available at major book stores.


Would a bad clutch fan on a 1994 Mazda B3000 cause it to overheat?

Yes it could.


How to remove and replace Mazda b3000 fuel injectors?

how do u replace fuel injector on 2001 b3000


What is the stock speaker size on a 2004 Mazda b3000?

stock speaker size for the mazda b3000 04 is 6x8


The clutch was replaced on a 1994 Mazda B3000 with a complete kit then it stopped working two weeks later the slave cylinder looked good and then seems to work again what else could be wrong?

94 the year of Ford auto clutch. It has allways been a problem. Plastic parts fluid leaks.


Where is the 1998 Mazda b3000 evr solenoid located?

i have a 98 Mazda b3000 auto 4x4. where are the shift solenoids located


Where is the speed sensor located on a 1999 b3000 Mazda pickup truck?

99 mazda b3000 where is the speed sensor located


Why Mazda b3000 clutch fail?

It is pretty hard to answer such a question without any more info. How many miles, driving conditions, fluids changed regularly. Often times clutches fail for a multitude of reasons but most often it is from driver abuse. By this I mean proper care for the clutch and trans. If it happened all of a sudden and you take care of it regularly, I would say that something inside the clutch pack went bad. Could be the throw out bearing but likely the springs that are on the inside of the clutch pack that keep the drivshaft from spinning in neutral are weakend or broken. However, my initial guess would be a throw out bearing but like i said it difficult to diagnose w/o more info. hope this helps


Where is the air conditioning drain hose in Mazda b3000?

show a picture of the a/c drain hose on a mazda b3000 pickup truck


Where is the fuel filter located on a 1998 Mazda b3000?

On my 1994 B3000 pickup it is located inside the frame under the drivers side door.


Where is the location of the Fuel Filter for Mazda B3000 Pickup?

Fuel filter for Mazda B3000 pickup is mounted within the left frame rail


Mazda truck b3000 where is the fuel pump reset switch loacted?

Mazda truck b3000 where is the fuel pump reset switch located


How do you lift a Mazda B3000?

not very easily


Where is the fuel pump relay on a Mazda b3000?

the fuel pump relay for a Mazda b3000 is under the hood. It is a 15 amp relay in the fuse box.


Does a Mazda B3000 have a chain or timing belt?

the mazda b3000 is basically a ford ranger. the 3000 designates the 3.0 v6 motor and it has a timing chain.


Why does the engine rev up when you push in the clutch on a 1998 Mazda pickup b-3000?

I have this same problem with my B3000. The only results I have found is that the IAC (idle air control) sensor needs to be changed. Also, you could try cleaning the throtle body plate and sensor. This could be causing your truck to not realease the throtle body when engaging clutch.


How does one replace the heater core in a Mazda B3000 6 cylinder?

2000 mazda b3000 down stop fan blower Heater up hill


Why does the 4x4 light blink on Mazda b3000?

its junk


What is proper tire size for Mazda B3000?

22570r15


Where can you find free pictures of rear brakes on a 1994 Mazda B3000?

Pictures for free of the rear brakes on a 1994 Mazda B3000 can be found by visiting a Mazda dealer.


Where is the daylight running light module located on a 1998 Mazda B3000?

I don't have an answer to the question but i would also like to know how to have daylite running lights on my 98 b3000.


Does a Mazda b3000 v6 pickup have hydraulic fluid?

The Mazda b3000 pickup truck does not have hydraulic fluid. None of the vehicles components use hydraulic fluid in any way.