answersLogoWhite

0


Best Answer

check your relays and fuses. mine flashes when i take one ofthose out and the car is on. Start there

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would your hold switch light flash on my Mazda mx-3?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would your hold switch light flash on my Mazda mx 3?

check your relays and fuses. mine flashes when i take one ofthose out and the car is on. Start there


What would cause a engine light to flash on a 2002 Mazda millenia?

A flashing check engine light is usually due to a misfire. see related questions below.


Why would the handbrake light stay on in a 1993 Mazda 626 when not in use?

Either your handbrake switch is broken and will not turn off or you have low brake fluid.


Where is the inertia switch on a 1993 Mazda mx3?

A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.


Why would a 1992 Mazda 121 light switch flick onto full lights whenever the car goes over a bump and how do you fix this?

You have a faulty switch in the base of your indicator/light stalk. This switch wears out with use so the lights can flip easily to High beam from Low Beam. The fix: Replace the switch assembly and stalk.


How to change the emergency light switch on a Mazda mpv?

Are you asking how to change the Hazard switch? What makes you think it is bad? They almost never go bad and I would be really surprised if it were. Have you replaced the Flasher Relay for the hazard lights.


Which light would turn on if switch a would close but switch b would remain open?

i think light two would turn on because it is in the middle of switch a and b


Why would your Mazda 3 gear shift be stuck in park?

neutral safety switch/ or reverse switch faulty thanks. how would i go about replacing the safety switch? is it difficult?


How would you fix hazards on a Mazda tribute that are stuck on?

If you mean they are on and flashing and your can't cut them off with the switch, the switch is bad.


Why would the bright lights not work on a 2000 Mazda B2500?

Switch? both headlights?


Why would all the dash lights and tack on 1998 blazer flash erratically continually?

I have a 99 blazer with the same problem. If i move the light dimmer dial from side to side it will stop. You can change the switch or from time to time wiggle the switch.


Why does my 4 wheel light flash on and off while driving even tho it is in the off position?

Bad wiring. Insulation has worn off of a wire(s) and it is shorting out the switch circuit. The switch could be bad, but that would be a strange break.