Jaffe reaction is used to determine creatinine.
pH of protein free filtrate must be below 2 because above this pH, some of creatinine is adsorbed onto the protein and is therefore lost.
Sulfuric Acid. The chemical reaction is Cu + 2H2SO4 = CuSO4 + SO2 + 2H2O
Mix Ethanol with Stearic Acid, use Sulfuric Acid as catalyst. Sulfuric Acid can be pre-diluted into the Ethanol. Boil the mixture under reflux. may need to do a few times after each reaction cycle, to use water to wash out the access ethanol & reaction by-product = water. Then re do the same, mix ethanol+sulfuric acid into the partial reactants (Stearic acid + Ethyl stearate) to fully convert the Stearic acid into Ethyl stearate.
Because Salicylic Acid reacts with Acetic Anhydride in the presence of H2SO4 and CH3COOH to give Aspirin. The sulphuric acid does not react. If you measure the volume/weight of the acid before the reaction and after the reaction, there will be no change. Note:-You can also use Acetyl Chloride in the presence of phosphoric acid instead on Acetic Anhydride.
You do not use muratic acid with car batteries. You use sulfuric acid. You use about 35% Sulfuric acid and 65% Distilled (de-ionized) water
= sulfuric acid VERY rare but it is used and with lots of caution... Muriatic acid DILUTED for concrete cleaning etc. =
Sulfuric Acid. The chemical reaction is Cu + 2H2SO4 = CuSO4 + SO2 + 2H2O
No, it is not possible to convert sulfuric acid to nitrous acid.
Mix Ethanol with Stearic Acid, use Sulfuric Acid as catalyst. Sulfuric Acid can be pre-diluted into the Ethanol. Boil the mixture under reflux. may need to do a few times after each reaction cycle, to use water to wash out the access ethanol & reaction by-product = water. Then re do the same, mix ethanol+sulfuric acid into the partial reactants (Stearic acid + Ethyl stearate) to fully convert the Stearic acid into Ethyl stearate.
You do not use muratic acid with car batteries. You use sulfuric acid. You use about 35% Sulfuric acid and 65% Distilled (de-ionized) water
Because Salicylic Acid reacts with Acetic Anhydride in the presence of H2SO4 and CH3COOH to give Aspirin. The sulphuric acid does not react. If you measure the volume/weight of the acid before the reaction and after the reaction, there will be no change. Note:-You can also use Acetyl Chloride in the presence of phosphoric acid instead on Acetic Anhydride.
= sulfuric acid VERY rare but it is used and with lots of caution... Muriatic acid DILUTED for concrete cleaning etc. =
Sulfuric acid functions as a catalyst in the synthesis of banana oil.
There are many chemical processes that use sulfuric acid catalysts - refining petroleum is a big one. Most processes that use it, use very concentrated acid because they want the reaction to go quickly.
There are many chemical processes that use sulfuric acid catalysts - refining petroleum is a big one. Most processes that use it, use very concentrated acid because they want the reaction to go quickly.
nitric acid
acetic acid, sulfuric acid nitric acid etc
Use 0.54 mL of Concentrated H2SO4 to 1000 mL DiH2O.