no, the 06 is a 5-hole wheel car and the 99 is a 4-hole wheel car
2500
Try running a wire through itTry low pressure air
If it is a half ton truck with a five lug bolt pattern 15in wheels, they will fit on most any DODGE vehicle's all the way up to the late 90s. I have never try it, but they may even fit the newer ones. Some of the older Ford wheels you could get on the older DODGE trucks. The center hole was a little tight, but the bolt pattern was the same.
Normally the hole to check the level and add gear oil is on the upper side of the transmission. You use the same hole for both. Can be on the driver's or passenger side.
Yes they will fit but depending on the wheel you are using such as the r\t wheel , you will have to mod.the upper '"a" arm around the upper ball joint for clearence,just don't grind down to far, or you will weeken the arm,failure may happen. the bolt pattern and center hole are the same as your stock wheels
Wheels on 1997 and earlier-8x6.5. 1999 and later-8x170mm. Not interchangeable.
You squirt it into the fill hole on the pass side of the trans case after removing the fill plug.
yes, most Toyota wheels fit on Chevy 1/2 ton, but they don't have the same seating on the center hole the Toyota is bigger so you have to rotate tires more often. so they don't cup.
Hole to China - 1999 was released on: USA: 10 October 1999
I believe a Ford 8 hole will fit any 8 hole. The center hole is bigger on Ford than Chevy and also Dodge.
They are round with a hole in the middle for an axle.