No, even if it can fit, the tool will not have sufficent power.
no it will burn the vacuum out too much voltage
Yes, the sockets are different in all battery chargers so you can only insert the correct battery.
No, you will damage the tool.
Yes, it can, but unless the battery has the same terminal layout, and the same physical attachment, it can't be done without lots of modifications.
You connect the batteries in series Red charger lead to one red battery terminal, then the black battery terminal of that battery to the red battery terminal of the second battery. Then black battery terminal of the second battery to the black lead of the charger.
With a 12 volt battery charger. Red + connected to + post on battery. Black - connected to any metal part of the vehicle. You do not have to remove the battery from the vehicle.
where can I find a battery for a durabuilt cordless tool set? 18 volt-Ni-Cd capacity of 1.3 Ah
If you look on the bottom of the fingergaurd on the scumbuster unit itself. You will see (if you squint, or use a magnifing glass) it says : Use only with charger 510297:03. THAT'S WHAT I SEEN ANYWAY .
A 6 volt Ni/Cad charger is needed.
Check voltage on battery 12 volt you should uses a 12 volt 2 amp battery charger connect red (positive) to the + side of battery and the black (negative) to the - side of the battery.
No
if it is any think over 1 volt it is not a cell battery it is just a 6 volt battery if you had a 1 volt then it would be a cell battery