If you're talking about the KA24DE engine block, then it will fit with no problems since your 92 already came with a KA24DE in it. It should work fine. It's the same engine in both years.
KA24E
under the hood passanger side there is a fuse block its in there
I found the thermostat on a 1993 Nissan 240SX (KA24DE, 2.4liter DOHC). It is approximately 2 inches to the left, and an inch or two above the fan pulley. There is a large hose going into it. The large hose coming from the top of the radiator going into the engine block DOES NOT go to the thermostat, but where IT enters the engine block you will see a small bolt for bleeding air from the cooling system. I needed to bleed air after installing the new thermostat - this was evident by the fluctuation in engine temperature before the bleeding process. Good luck, Alan
The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.
Open the drain valve on the side of the engine block.
Spring and "bulb" assembly go TOWARD the engine block.
yes,also ls1 ls2 and a 5.0 bascally any v8 fits perfectly
On engine block.
it is where the frost plug is normally
Sandwiched between the heads and the engine block.
The starter on a 1988 Nissan Stanza can be found on the inner side of the engine. It is between the gear box and the engine block.
The 2001 Nissan Pathfinder engine number can be found on the engine identification plate. The engine identification plate should be attached to the right side of the engine block.