0
Will a 1995 Chevy 4.3 vortec engine work in a 1999 Chevy blazer?
Wiki User
∙ 15y ago
From what I've experienced, up to 1995, they don't have a crank sensor and 1996 and later has one. It would reason that it would be a lot of work to get a crank fitted or cut and then install a timing chain cover to accept the crank sensor. Other than this. I would think it would work. Maybe look for a kit that would do this for you. Good luck. yes but would be different wiring
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the fuel pressure regulator on a 1995 Chevy blazer 4.3L vortec?
It is in the throttle body.
How do you replace a fan belt on a Chevy blazer 4 x 4 need diagram?
how to change the fan belt on a 1995 Chevy blazer vortec motor?
Where is the oil pressure sender or transducer on a 1995 Chevy S-10 Blazer with a 4.3 Vortec engine?
Mine is on the Drivers side of the Block, Behind the Intake Manifold.
Where is the maf sensor located on a 1995 Chevrolet Blazer with a vortec engine?
Apparently, there is none. They started using them in 1996.
What v6 engine come in a 1995 Chevy s10 blazer?
The 4.3L.
Will a 2002 Chevy blazer transmission4l60e fit a 1995 gmc jimmy 4.3 v6 vortec?
No it will not. The design of the 2002 Transmission is different.
How much is a transmission flush?
how much should it cost for tranny flush on 1995 s-10 Chevy blazer 4x4 4.3lt vortec
Will a 96 blazer transmission fit a 95 s10 pickup?
Will a Chevy blazer engine fit in a Chevy s10 pickup
Where is the purge valve on a 1995 Chevy Blazer?
Assuming we are talking about the 4.3l, vin W engine, it is located on the driver side of the Vortec intake manifold. It has a RED electrical connector plugged in to it. I am fairly certain it has 2 wires.
Where is the starter located on a 1995 Chevy Blazer XL?
At the left rear under the engine.
Will a 87 vortec 350 fit in a 1995 Chevy that had a 350 vortec and will all the wiring fit and hook up directly?
First of all Chevy did not make a vortec engine in 1987 or 1995, those engines are TBI / Throttle body injection engines. And yes they will interchange with no problems.
Where is the EGR valve located on a 1995 Chevrolet Blazer with a vortec engine?
The valve is at the front of the engine just behind the A/C Compressor. Its just above the thermostat. Be careful as for some unknown reason GM has designed this valve without polarity. It can be installed upside down which will yield less than impressive results. Where is the EGR valve located on a 1995 Chevrolet Blazer with a vortec engine?
