Chevy S-10
Chevy Blazer S-10

Where is the EGR valve located on a 1995 Chevrolet Blazer with a vortec engine?

141516

Top Answer
User Avatar
Wiki User
2007-07-15 15:28:21
2007-07-15 15:28:21

The valve is at the front of the engine just behind the A/C Compressor. Its just above the thermostat. Be careful as for some unknown reason GM has designed this valve without polarity. It can be installed upside down which will yield less than impressive results. Where is the EGR valve located on a 1995 Chevrolet Blazer with a vortec engine?

234
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Apparently, there is none. They started using them in 1996.

User Avatar

A Chevrolet Blazer with a 4.3 liter vortec engine will take approximately 6 quarts of oil. The recommended type of oil is 5 W 30.

User Avatar

The shift solenoid on your 1994 Chevrolet Blazer, is located on the top of the transmission. The solenoid will be labeled.

User Avatar

If your talking about the Chevrolet K5 Blazer made from 1969-1994, the most powerful engine was the 350 ci Small-Block V8 engine that puts out 255 hp and was available from 1969-1970. If your talking about the Chevrolet S-10 Blazer and the Chevrolet Blazer made from 1983-2005, the most powerful engine is the 4.3L Vortec 4300 L35 CPFI V6 engine that puts out 200 hp and was available from 1992-1994.

User Avatar

Usually found behind/under the glove box or behind the kick panel.

User Avatar

It is inside of the engine oil pan. You will have to remove the oil pan to get to it.

User Avatar

The starter price for a 96 Chevrolet 7.5 Vortec engine is around $200. The actual price depends on where the starter is purchased and if it is refurbished.

User Avatar

Vortec is the motors name in the blazer and it is a great motor

User Avatar

The ground strap on a 1997 Chevy Blazer 4.3 Vortec is located along the bottom of the engine near the frame. It ensures that electricity flows properly through the entire vehicle.

User Avatar

A 1995 Chevrolet Tahoe has a 5.7L 350 TBI V8 for a engine, not a vortec.

User Avatar

The 1994 Chevrolet Astro V-6 engine temperature sending unit can be located on the front of the engine. The temperature sending unit will be next to the thermostat housing.

User Avatar

Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?

User Avatar

is this a vortec engine 4.3 liter casting number on Block 10066061 - 4.3lg

User Avatar

It's at the top rear of the engine near the distributor.

User Avatar

It's located on the coolant reservoir on the passenger side fender well.

User Avatar

From what I been reading there is no egr on this engine.

User Avatar

There will be 3 core plugs on a 4.3L V6 Vortec engine: 1 each side of the block and one at the back, in the bellhousing area.

User Avatar

Drivers side of engine, between the #3 and #5 spark plug.

User Avatar

There is a fuel diagram for a 94-95 Chevy Blazer with a CPI 4.3 Vortec engine in the service manual. It shows the path the fuel travels from the fuel tank all the way to the injectors.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.