Same problem and question, compressor locked up. Battery won't keep a charge. Does the belt send charge to battery?
4g63, you will need a new trans, engine wire harness, all accessories, like ac compressor, and alternator, and ecm. and engine mounts...fits perfectly. or you could use a v6 from an avenger or sebring.
The chrome wheels are for sure not plastic. I would think that if Chrysler calls it a Genuine Wood Dash, then it is wood and not plastic. Looks can be deceiving.
Sebring, Florida to Oxford, England is 4,353 miles as the crow flies. A nonstop flight of this distance would take 7 hours 55 minutes.
there is probably a broken solder joint on the instrument cluster circuit board. if you look at the circuit card itself there will be 2 resistors that look burned. by them there is a solder joint that connects the front and back of the board. check to see what side is not making connection and add solder to it. it takes a couple hours to do, and the solder job doesnt need to be perfect.
What does the water outlet housing look like 2001 Sebring (2.7liters) V6? It depends on the engine type... For the 2.7L V6 engine code R it looks like a black plastic piece with three hoses going into it. It has a brass bleed valve on the very top and the coolant temp sensor mounted vertically just below it. It is mounted on top of the engine block on the passenger side. Search for 902-302 for an aftermarket solution.
It was replaced by the Chrysler Sebring.It was replaced by the Chrysler Sebring.
The solenoid pack on a Chrysler Sebring is on the bottom of the transmission. It is a bolt on unit and can be easily replaced.
The Chrysler Sebring drive belt can be found on the front of the engine. It is also referred to as a serpentine belt. The timing belt can be found behind the front engine cover.
When a Chrysler Sebring is stalling it is possible that poor gasoline has been used. It is also possible that the car needs the spark plugs replaced.
Struts are not adjustable, and must be replaced if faulty,
No. If the airbags have deployed, they will need replaced.
The alternator is driven by the serpentine belt. Follow the belt around the engine and you will find the alternator.
Yes, the system will not function without sufficient refrigerant.
If the timing belt in the 1998 Chrysler Sebring causes damage to the valves and the head when it breaks, they will have to be replaced. It is recommended that the water pump also be replaced when replacing the timing belt.
No, the wiring is different.
Every 100,000 miles.
There is not a diagram under the hood showing how to replace the serpentine belt. Can you show me a diagram?