Want this question answered?
Not without a lot of work, because the axles are different: Up to 1968 VW used swing axle transaxles, and from 1969 they used independent rear suspension. IRS is far safer for you than swing axle, so if I could get the whole 71, I would transfer its entire rear suspension to my 65.
What about them? There are 11 on a 4WD if that's what you're asking. Z-71 so you'd have 11. 2WD will only have 6.
the rearend in the fury3 is an 8 3/4inch 10 bolt the car its going into is the 71 Plymouth satellite is an 81/4inch. The 69 Fury's overall axle length is longer than the 71 Satellite. Also the spring perches are further apart.
The r71 does not have an upgradeable gearbox.
My 71 CB 500 is 22mm I believe. Try that
All chevy 350 engines use the same bolt pattern to bolt the bell housing to the block so the 71 model block should bolt up the same although there may be slight differences otherwise.
Rear Axle MeasurementsMEASURED ACROSS WHEEL MOUNTING SURFACE56 1/2" 71-77 Ford Maverick 8",57" 71-74 V-8 Mavericks 8", All '75-77 6's & 8's Maverick 5 Lug 8", 49-51 Ford, 57-59 Ford 9"57 1/4" 64 1/2 - 65 Mustang58" 78-88 Mid sized GM Car, Malibu/Monte Carlo (82 up Metric Studs), 80 Granada & Lincoln Versailles,67-70 Mustang/Cougar/Fairlane, Regal with 10 bolt axle, S-10 P.U., 65-67 Nova58 1/2 " Ford Grenada59" 68-83 Corvette60" 55-64 Chevy Car, 67-69 Camaro, 64-67 Chevelle, 68-74 Nova, 71-73 Mustang/Cougar, 84-95 Corvette60-61" 64-69 1/2 ton 2wd Chevy/ Some GMC 6 lug rear end 12 bolt Coil spring set up Possible gear ratio's 3.7062" 64-77 Chevelle, 73-76 Torino, 89 Trans Am,70 2wd 6 lug rear end 12 bolt Possible gear ratio's 3:08, 3:40, 3:7370-81 4wd 6 lug reared ...............................................................71- Newer 2wd trucks use a 5 on 5 lug pattern71-76 Full Size Cars " "" "" "60" 60's GMC and some Chevy's Dana 44 or Dana 60 with leaf springs 6 lug, Gear ratio's 3.21 to 3.92. GMC V-6 used a 3.21 Dana 44 used a standard Chevy 1310 yoke, Dana 60 used the heavy duty yoke which takes the larger 1350 yoke.
2.100
plate in floor next to footrest (RHD) - ALLEN KEY -TOP BOLT - BOTTOM BOLT FROM UNDER THE CAR
6 lug on 5.5 center to center
yes. jeep stanardized bell housing bolt pattern in 71 i believe. just motor mounts and exhaust and radiator to worry about.
Yes, but the transaxles are different. A 66 uses the swing axle; 71's are IRS.