A 4500 watt element will work on a 20 amp breaker if it operates at 220 volts or less. It will simply trip the breaker if the load is greater than 20 amps at 220 volts.
element
No lead weights are just lead in the form of a wheight
Just carbon ... it IS an element.
no, it is still the same element just a different type
Hydrogen is a pure element just like oxygen. This means that they only contain one element.
Check the MFG for the amps it uses, if it is suppose to be on a regular 20amp line, then replace the breaker with a 20amp breaker. With the 30amp breaker,it will work, but if there is a surge, you could send too much power to the appliance and fry it. Most refrigerators, are just on a regular 120v household outlet. Besides a 30amp breaker must have 10ga wire, if the wire is 12ga,it can not be attached to a 30amp breaker.
Technically, they can be on a 15 amp breaker when you use 15 amp outlets. There is a difference. Be sure to check your local code (just call the city building department and tell them you have a code question). some cities require the bedroom outlets to be on an arc-fault breaker.
ITS SHOULN'T BE JUST A FUSE IT SHOULD HAVE A CIRCUIT BREAKER TOO. THE CIRCUIT BREAKER OPENS IF YOU HOLD THE SWITCH TOO LONG. ITS 20AMP ON MOST CARS THAT I WORKED ON. ITS IN THE FUSEPANEL ON MUSTANGS. GOOD LUCK PAUL G
Have an electrician wire you a proper line for the appliance. You were just kidding about the 100A, right? 10, or 20amp, not 100.
I don't understand the question, but if you want to make the line into a 20amp instead of 15amp, you just install a 20amp breaker, but remember,the wire must be 12ga wire to be connected to a 20amp breaker.
Essar Telecom 4500 cell phone towers in India
on a 2004 it's #1 20amp fuse in the box on the side of the dash board on the drivers side. Just look for any 20amp blown fuse in this box and you will find it. RH
The wave breaker is just a furniture item.
let me just say about 4500 miles
first run electric cable to garage,10-3 with ground is best,you will have to put at least a 30 amp box in garage more if running 220. if just lights and power tools on 110 then you will be fine!! in box connect red wire to proper lug in box and black wire to proper lug. run 14-2 to lghts!! you can use 12-2 also it is a heavier cable!! at house breaker box run the 10-3 cable to its own breaker in box,at least a 20amp breaker!! red and black wires go to breaker and white goes to neutral bar connect ground to ground bar or neutral bar also!! use a double pole breaker in main box.
If you can reset it, then it is not a fuse it is a breaker. You use then so you do not have to replace a fuse, you can just reset the breaker.
It depends on the rating of the furnace. There should be a plate or sticker somewhere on the furnace that shows the rating. If you are just powering a blower motor the rating will be lower than if you have an electric heating element.