The Hemi requires different wiring, computers, (including abs and its sensors), ac lines, ............
It is possible, but it would be easier and cheaper to by a 2003 truck with a hemi.
yes, you could get the hemi in the 500 starting in 1966 and in 67 you could order the 440 or the hemi.
To make a 318 into a slant 6 engine on a 1970 Dodge Dart you will need new engine mounts, fuel lines, and bigger radiator. What needs to be done first is to remove the old 318 and add the new engine mounts first. This is not something that should be done if you don't have the proper tools and equipment.
well i have a 2004 dodge ram 1500 wit the 5.7 hemi i put the k&n cold air intake in it made alot of difference , and the superchips programmer cut the mufflers out and it backfired for a while but the performance setting on the programmer made it stop and run better its pretty quick
Look right behind the alternator. Its held only by one 10mm bolt. you dont even have to remove the alternator. got it done in 5 minutes. P.S. make sure you disconnect the negative cable on your battery.
They need to experience hard core sex for this to be done
No but they make plenty of Hemi heads for the Chevy and some even better. Hemispherical combustion chambers only benefit so much. I beleive the vortex has them. if you like the plug placement, enginers have been arguing about that for years, all just agree it needs to be exhaust valve.
No. No.
No unfortunately not, I wish though.
They make up whatever necessary to avoid doing what should be done.
Chevy never made a hemi motor
It can be done, yes. You just have to make sure you wire them in parallel.
Make sure you clean up