Will a 700R4 transmission fit a 1986 Chevy Camaro?
May take some modification in some instances, but yes, it can be done
Answer 700r4 that should be a 700r4. its a 4 speed automatic. unless its a v6. then its a 200r4 or something like that.
The car has a 700R4 transmission. 4 speed automatic
What are the problems when swapping a turbo 350 for a 700r4 transmission in a 1986 Chevy silverado with a 350 motor?
My 1986 GMC High Sierra 1500 stock transmission is a 700R4. My 1986 GMC High Sierra 1500 stock transmission is a 700R4. it could also be a th 400
What size of transmission does a 1992 Chevy silverado extended cab 4x4 automatic have 1500 series and model number of transmission. what will inner change?
700R4 from 1986 to 1992 should work
Yes, I have one sitting in the driveway.
where is the fuse box in a 1986 camaro
If it's an automatic it's probably the 700R4
8 quarts with an empty converter 6 just for the tranny
Will a 700 transmission with a 350 motor from a 1986 camera work in a 1956 Chevrolet truck when the 700 transmission has no vacuum lines?
Yes it will. The 700R4 uses a control cable that attaches to the carb linkage for shift points and shift pressures. Do not confuse this with a "kick down" cable because it is totally different. A good transmission shop can reconfigure the 700R4 to work without the electrical control harness that it required in the Camaro. The great point of the 700R4 is that it has a first gear that is about 25% lower than… Read More
The order is 1,2,3,4,5,6
Yes. You could get them from the factory with them.
Between 12 and 13 qts. if completely empty.
No you do not.
0 degrees top dead center
195 - 220 Degrees [F]
A Chilton's manual is a good place to start
It's internal, inside the alternator.
The 86' Z28 comes stock with a 5.0 or 302 their both the same engine. a 1986 chevy camaro does not come with a 302 its a 305 a 302 is a ford motor not a che y motor know your facts i am a camaro fanatic i know these things about them plus i own a 1986 chevy camaro irocz z28 and its all original with the 305 4barrel carb thats how it should… Read More
Lower rear end of the engine
Yes. It has an O2 sensor on the exhaust y-pipe.
Yes, I have one. All GM parts.
The transmission oil goes in thru the dipstick tube.
Look in your owners manual if you still have it and if you don't go see your Chevy parts man and he can help you out.
lower rear passenger side of engine
There is only one.
yes the bell housing should bolt right up. its basically the same transmission for both vehicles, but you might check and see if the tail pieces match up. but other than that its basically the same motor and transmission for both. the z28 should have a 305 if so it would certainly bolt up. overall yes it will work. i just put a motor from a 91 sierra in an 85 camaro z28 and had… Read More
If it is an automatic transmission, Dexron III or Mercon are both acceptable.
Chevy never made a 1986 IROC-Z convertible, not till '87 - so the answer is no.
Follow the top radiator hose down to the water outlet; your stat is in there.
Will a 1986 s10 2.8v6 transmission work for a 1971 chevy pick up conversion from stick to automatic?
The 86 2.8L automatic transmission will not bolt up to a 71 Chevy engine.
That should be the 400 turbo.
That would be the 400 turbo.
on my Chevy camaro its super glue and duct tape, your might be different.
Hi, will 18" 5 lug 2011 camaro wheels fit a 1995 15" 5x5 chevy sportvan van hub?
There are 6 bolts that holds the transmission to the engine.
YES. The 74 and 86 engine blocks are the same as far as DESIGN.
Would a200r4 be a good replacement or a 700r4 for a 1986 Chevy P30 motorhome with 454 engine and 400 turbo?
Honestly? I'd keep the Th400 and add a Gear Vendors OD unit to it. For the cost of that and driveshaft modifications, it'll still be cheaper than building up a 200R4 or 700R4 to the point of being able to withstand the torque of the 454, and you'll still have what is, in my opinion, a superior transmission to both of the R4s.Swapping in an electronic 4L80E into a mechanically controlled setup isn't the most… Read More
Will the manual transmission form a 2.5L 1988 GMC S15 truck mount to a 4.3L V6 motor out of a 1986 Chevy Caprice Classic?
The 1986 Chevy Caprice Classic didn't have a 4.7L V6
it is under the dash in a panel above the gas pedal . you must remove two screws to let box down.gmjim
If it's an automatic, you'd need dexron.
i went to the gm dealership and they quoted me at $45 because of the chip on the key
Depends on mileage, condition, engine, transmission, and options. Click the link.
If it is a standard transmission S10 maybe they are talking about the "throwout bearing" which is part of the clutch operation that can go bad.
it is 5x4 3/4 or 120.6mm same as corvette, firebird, camaro, s-10 p/u and others.
Yes. Those 2 years are the same.
Does a 1986 camero automatic transmission with a 2.8 ltr v-6 match up with a 2005 Chevy blazer with automatic transmission with a v6?
No, different bolt pattern.
I doubt it very much as electronics in the car are changed every year.