If you have the D16 Engine then any D-series 5-speed transmissions will work.
No, the engines are completely different 3.3's , and the transmissions have different electrical plugs.
Not without an adapter.
95-99 eclipse or talon tranny no problems fit perfect but make sure you get a esi if yours is a esi or same with tsi get a tranny to fit a tsi they are different
yes
more then likely being the engines are so different youll have to basically have a donor car to use as youll probly need the wirehareness and computer along with the engine and tranny and possibly the drive shafts as well as custom mounts for the engine and tranny
Yes, you just have to disconnect the two from each other before you pull the engine.
You need a cherry picker with a leveler bar to be able to take the engine and tranny out in one piece.
most of the emounts are located on the transmission so you should be able to do it with out even having to brace the tranny.... it is possible you just have to have patients and go slow takin it out, it'll be tight.
the tranny dipstick is at rear of the engine on the drivers side of the car the tranny dipstick is at rear of the engine on the drivers side of the car the tranny dipstick is at rear of the engine on the drivers side of the car
yes but you may need to change the trans control module too
The tranny ( or transaxle / transmission ) on a 1993 Mercury Tracer is in the engine compartment bolted to the engine on the drivers side of the engine
not without a lot of head aches.