answersLogoWhite

0


Best Answer

It will bolt up. You can not install a 8 valve head on a 16 valve lower end without changing the pistons. The injection is completely different and wireing as well as well the computer. I just completed the swap with ALOT of headaches. believe it or not LOL we used a router with a mill bit to cut down the pistons talk about okie but hey its running perfect now 2000 miles later. my advise is keep the 8 valve head with the car change the pistons and use ALL the brackets off the 8 valve engine.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Will a Geo tracker 16 valve engine block from a 94 or 96 fit in a 92 Geo tracker Which has an 8 valve engine both are 1dot6 L I think?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the id number on a 5 liter engine?

I think its on the block above the starter.


What is a good engine to put in a car?

a good engine to put in a car i think is a 350 small block with a twin turbo. another is a 440 big block v8 with twin headers


Where is oil filter on n16 pulsar?

i think its at the back of the engine block. In Australia in on the drivers side


Does stalker tracker work?

i dont think a stalker tracker would work sorry


Where is the location of the coolant drain plug on the engine block of the 95 S-10 2.2L engine?

I think it's under the exhaust manifold


Can you spray paint a car's exhaust pipe?

I think that as long as you use the paint use for the engine block


Where is the thermostat located on 1994 Nissan Maxima?

I think you have to follow the lower radiator hose to the engine block.


What does it mean when a car has a motor but needs a block?

It means don't buy that car! Look for a better one that actually runs. The block is the main component of the engine/motor. All the components that make up a working engine are built on the block. Think of it as the basement or foundation of a house.


Where is the temperature sender on a 1990 Bronco with the 302 ci engine?

Should be on the top of the block near the water pump. I think it is a two wire pair that screws into the block.


Will Geo Tracker front lockout hub interchange with a Kia Sportage?

i do not think so, geo tracker was not made by Kia .


On a 1997 geo tracker engineafterthe engine warms up you get a noise like loose tappets what do you think would be wrong?

The tappets may need adjustment or replacement, due to wear.


An engine that had antifreeze in the oil pan and it set a long period of time And I think it's locked?

If you are lucky, then the head gasket is blown. If you are not lucky, the engine block or cylinder head is cracked.