Yes it will, the banshee engine is just a water cooled version of an RD engine. The bottom ends are identical except for the rotor end of the crankshaft is slightly longer. You will probably want to get the banshee wiring harness also. (Also a RD350LC was built where the LC at the end stood for Liquid Cooled).
yes it will but you need to change the front brackets up
Yes, but you will need do some fabrication to the frame in order to fit it in correctly.
The 08 Yamaha Raptor 700 frame can be used to replace the 06 Yamaha Raptor 700 with a little bit fabrication.
it is on the frame under the lift foot peg
on my banshee it is on the lower shifter side frame tube near the shifter or behind. probably covered in paint.just in front of the LH footpeg on the frame
The last six digits of the VIN number is the serial number on a Yamaha Banshee. The VIN number is found under the stator cover on the lower left part of the frame.
what year is your yamaha vx with frame and engine number of 3JC-2186-01
Well in a quad mag they had a 800cc FI Honda V-twin motor stuffed into a Honda 450R frame. So I would assume you can put anything in it with some modification.
on your main frame in between your a -arm and the frame on your left side when your sitting on the bike the frame number is there and on ur left side on the engine case there is a permenet tag with your engine number on it
its your engine oil dipstick
Most likely, if the 1998 is a 250 also
Tjhe 4BE prefix suggests a Yamaha 225DT from 1992.