yes it will but you need to change the front brackets up
Yes it will, the banshee engine is just a water cooled version of an RD engine. The bottom ends are identical except for the rotor end of the crankshaft is slightly longer. You will probably want to get the banshee wiring harness also. (Also a RD350LC was built where the LC at the end stood for Liquid Cooled).
yes it will the only time the frame is different is 1988 and down 1989 and up are all the same
it is on the frame under the lift foot peg
on my banshee it is on the lower shifter side frame tube near the shifter or behind. probably covered in paint.just in front of the LH footpeg on the frame
on the left side, bottom frame rail, just under the engine in front of the foot pegs
The last six digits of the VIN number is the serial number on a Yamaha Banshee. The VIN number is found under the stator cover on the lower left part of the frame.
When sitting on the seat it is under the left foot rest on the frame rail under the engine
white with red frame
On a 1997 Yamaha Warrior with the original frame it is located on the frame bar underneath the motor, and a few inches in front of it. If it has a replacement frame, it may not have a vin, because on a replacement frame they are supposed to be cut out of the original frame and welded to the frame bar underneath the rear fender on the passenger side of the quad.
what year is your yamaha vx with frame and engine number of 3JC-2186-01
Wiring harness is differant but other wise its all the same
Well in a quad mag they had a 800cc FI Honda V-twin motor stuffed into a Honda 450R frame. So I would assume you can put anything in it with some modification.