0
It could.
It could.
Wiki User
∙ 12y ago
Wiki User
∙ 12y agoIt could.
Add your answer:
Earn +20 pts
What would make a loud tick-rattle noise from the engine but no warning lights come on?
I just had that problem on my 2000 Acura 3.2 TL. I needed to replace the belt tensioner.
On a 2000 Acura 3.2 TL what would make a loud tick-rattle noise from the engine but no warning lights come on?
You might need to replace the automatic belt tensioner.
Why does a 3.9l dodge tick?
Sounds like a sticky lifter ...........
Where would the timing marks on a 96 Mazda millenia would be?
Installing the timing belt on a Millenia. I have a Mazda Millenia with a 2.5 liter engine that I just replace the timing belt and tensioner on. In the explanation left and right are in reference to how you are looking at the engine. The timing marks are hard to find. Above the crank sprocket, there is an upside down triangle cast into the block. Behind the crank sprocket, there is a flat disc that rotates with the sprocket. This disc has a notch in it that needs to be lined up with the upside down triangle. Looking at the front of the engine, the camshaft to your right has an arrow on the sprocket. Line this up with the very small tick cast into the block. This should line up the arrow at about a 10:00 o'clock position. On the camshaft located on your left, the original factory tick mark for timing can't be seen without a mirror when the engine is in the vehicle. So, as an afterthought, Mazda came up with another solution. There are two tick marks on the block at about the 12:00 o'clock postion. On the camshaft sprocket are two small drilled out holes that need to line up with these two tick marks. If you haven't already, the hydrolic tensioner needs to be removed, compressed, pinned, and reinstalled. Then remove the idler pulley just below the camshaft sprocket located to your right. Route the belt over the crankshaft, right side idler pulley, right side cam sprocket, tensioner idler, and then left side cam sprocket. While putting tension on the belt, reinstall the missing idler pulley. Then remove the pin from the tensioner releasing tension on the belt. Rotate the crankshaft twice and recheck the timing.
What does it mean when an engine has a tick?
a lot of times its your timing belt, if its more of a knock its could be a rod knock
What would cause a 2005 dodge neon to tick when turning on but then it starts on 2nd or 3rd try?
starter motor is bad
What is the duration of ...tick...tick...tick...?
The duration of ...tick...tick...tick... is 1.67 hours.
Why does your car tick when it is running?
moving parts friction wear and tear on high milage engines .worn tappets.bad timing belt or chain.if ticking is loud it could need a timing belt changed as if the belt breaks you could seriously damage your engine
When was ...tick...tick...tick... created?
...tick...tick...tick... was created on 1970-01-09.
When was Tick Tick Tick - How I Met Your Mother - created?
Tick Tick Tick - How I Met Your Mother - was created on 2011-11-14.
What cause tick tick tick sound when trying to start a dodge desial 2500 truck?
If it's before you actually turn the key to the start position, Cummins engines use an electric priming pump, so it might be that. If you're hearing that sound as you try to actually start the truck, and it doesn't crank, then your starter is toast.
What is that song that goes you make me want to tick tick tick?
yeah yeah yeahs : Tick
