0
No. air in brake lines will cause you to have a mushy pedal or no brakes at all. normal causes for brakes to drag are either bad calipers/wheel cylinders or rubber brake lines to have deteriorated on the inside forming a kind of one way valve or the emergency (hand) brake cable is hanging up/frozen.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Chevy Venture brake line leaking?
When a brake line is leaking on the Chevy Venture the brake line should be replaced as soon as possible. A leak, however small, can cause hydraulic fluid to escape the brake line which will cause a loss in brake pressure. The brakes should be bled of air after the new line is put in to remove gaps in brake pedal pressure.
What can cause drag on a vehicle?
Air hitting the vehicle will cause drag. The bigger the vehicle the more are drags.
Brake peddle hard but goes down slowly?
Air in a brake line or a bad master cylinder could cause this. Bleed the brake lines if you have been working on any brake cylinder. If this happened without any warning, the master brake cylinder is probably the cause and should be replaced.
What brake pedal is the cause of air being in the brake system?
The brake pedal has nothing to do with it. If air is in the system then bleed the brakes.
What could cause your brake petal to feel soft?
Air in the brake lines
Why is my Offside rear brake recording little or no effort?
Air in the brake lines. Severly worn break pads. Worn brake boost piston. Cracked brake line on that brake. Loose brake line.
Why is the brake pedal feel so low and spongy after a brake change on a 1995 Honda Civic?
You probably have air in the brake hydraulic line. Bleed the air out of the brake lines.
What is the term that refers to the friction due to air resistance?
Drag . As in drag-parachute. Drag is also employed when a pilot engages the plane's flaps, while traveling pretty much at full speed, as an air brake to allow the pilot's target to get ahead.
What is the service line in a 18 wheeler?
there are 2 air lines from tractor to trailer.one line is a control line witch tells the supply or service line how much air to send to the brake pods. the control line is controled by the brake foot valve.
How long does it take for the air to flow through the lines to the brake after the brake pedal is pushed?
Typically brake systems in cars and pickups have brake fluid, not air in the lines. There should never be air in your automotive break line
What would prevent brake fluid from reaching the rear brake line?
air lock in the poportioning valve
When you apply your brake you hear no air?
More info, please. Namely, are you talking about an air brake system? You should hear some air as you apply and release the brake, but you shouldn't hear a continuous air sound as the brake is applied - if so, you've probably got a compromised air line or a bad brake chamber.
