Yes, FM does travel in space. In fact I believe that at least some space communication utilizes FM signals (data and voice).
FM stands for frequency modulation and AM stands for Amplitude modulation. In FM, frequency of a modulating signal is modulated using carrier frequency i.e. more data can be transmitted using a little space and also it is safe to transmit the information while in AM amplitude of a modulating signal is modulated using carrier frequency i.e. more space needed for transmitting the information. That's why we use FM in place of AM
FM signals can be detected using a frequency discriminator or a phase-locked loop (PLL) demodulator. The frequency discriminator converts the frequency variations of the FM signal into amplitude variations, which can then be amplified and filtered to recover the original audio signal. In a PLL, the incoming FM signal is compared to a locally generated signal, allowing for the extraction of the original information by tracking the phase differences. Both methods enable effective retrieval of the modulating audio or data signal from the FM carrier.
FM = Frequency Modulation; AM = Amplitude Modulation; each being a technique by which the speech signal is imprinted onto the carrier signal (the one to which you tune the radio). FM is a higher frequency than AM. FM also only uses the 2.7hz upper side band of the frequency while AM utilizes the entire 6hz both the LSB, USB and the .6hz carrier wave. That allows AM to travel farther than a FM signal.
Mix it with a local oscillator whose frequency is (the IF frequency) away from the frequency of the FM signal you're interested in.
the digital signal is converted to analog signal after using by transmitted antenna
boz there is lesas interferance to the signal as a signal travels...............
because demodulated FM is an audio signal, which the frequency is much smaller that is why it can be transmitted alone. It need carrier which has large frequency. Modulated signal is an audio signal + carrier that is why the amplitude is higher.
The FM signal is more amune to static in the atmosphere than AM signals.
FM or frequency modulation is a means to vary the frequency withing a set basic frequency and transmit it. FM radio demodulate the frequency extracting the signal that made the frequency shift at the source.
The limiter clips the top and bottom of the FM signal to remove any AM signal or static that was picked up. This prevents the FM discriminator from seeing those unwanted signals and inadvertently converting them to audio, scrambling the intended audio signal. Simply put, the limiter blocks interference and static making FM reception very clean.
Fro transmitting FM signals from one point to another,one need to have a full system that transforms your signal. The FM transmitter and FM modulator are two parts of this system and they are both necessary in making the system function as desired. The transmitter is the part that dissipates the FM signal into the air so that it can be received by antennas somewhere else. The FM modulator, on the other hand, is responsible for piggybacking the signal onto the carrier signal. Refer american-writers.org for more information.
- Advantage of AM1- Corverage area of AM Reciever is wider than FM because atmospheric propagation2- AM is long distance propagation because λ3- AM Circuit is cheapter and non complex than FM.4- AM have bandwidth limited and FM unlimited- Disadvantage of AM1- The only one way to withance to noise happen is increasing power transmite2- Signal of AM is not stronger than FM when it propagate to obstacle. (Urband)3- Only one sideband of AM transmites Information Signal, So it loss power on other sideband and Carrier.4- Noise mixes AM Signal in amplitude when it propagates in free space that it make difficulty to recover Original Signal at reciever.