0
I think you will find that the C50 forks have a smaller fork seal size, thus they would most likely be less stable even if they matched up fender and axle wise. I'm going by the 2003/2004 VL1500 which has dual front disc brakes. Maybe the older Intruders might match up.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the Front fork tube diameter on a 1996 Suzuki Intruder VS800 motorcycle?
The front fork tubes in a 1996 Suzuki Intruder VS 800 are 40mm.
What is the front fork oil capacity 1997 GSXR 750?
what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr? what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr?
Where can you find a free wiring diagram for suzuki intruder 1500?
What colors are the front signal light wires
What is the carburetor jet size for the Suzuki Intruder 1400?
125 front main 140 rear main
How do you remove the driver's seat on a 2007 suzuki 800c intruder?
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Where is the engine number located on the Suzuki Intruder 1500?
The engine number, on your Suzuki 1500 motorcycle, is located on the front of the engine block. The engine number is cut into the block.
Unable to align shift forks in 88 Suzuki?
use a ruller or level and set it across the top of the forks i would probally put the front tire on first
Where is the starter solenoid located on a Suzuki intruder 1500?
under left side cover. you will see the battery cable connected to it. on the front side.
Where is the battery located on the2004 suzuki intruder?
ON THE VS 800 AND VS 1400 THE BATTERY IS IN FRONT OF REAR WHEEL UNDER THE BIKE ON THE VL 1500 TI IS IN THE FRONT ON THE BOTTOM
How do you lock the forks on suzuki boulevard s40?
2005 boulevard has a slide plate that cover the key slot to lock the front forks located on right side below the headlight. Hope this helps
Where is the neutral switch on a suzuki intruder 1500?
it is in the cver right in front of the tool compartment where the shift rod hooks up to ngine it is right in front of it has two screws holding it in and has one wire going to it
What model are the front dampers for a 1996 Suzuki RM250 Or how can i find out what model they are.?
Pull your forks apart, take the damper rods to your local shop and they should be able to help you.
