Chevy Tahoe
Chevy 350

Will the motor out of my 1990 Chevy subarban work in my1997 Tahoe?

567

Top Answer
User Avatar
Wiki User
Answered
2012-01-26 20:26:38
2012-01-26 20:26:38

NO. You need a VORTEC engine from the year 1997 to 1999

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


que aceite lleva el motor de tahoe "What kind of motor oil does a 2007 Chevy Tahoe use?"

It can be done it will take A LOT of work it won't bolt right up.

behind the glove box that is where mine is on a 1996 Tahoe

There is no fixing broken motor mounts. Replace them with new ones.

Need firing order on a 2007 Tahoe with a 5.3 liter motor?

if the motor size is the same then yes but there is a heater tube in the driverside header that will either need to be added to the header or deleted from the truck.

Why will my abs break light and seat belt light stay lite on the dash of a 2003 chevy Tahoe while the motor is running? Please help. Thank you.

Its located on the passengers side behind the glove box right next to the blower motor......

in the distributor located on top rear of motor

It does not have one. It has a 4x4 Actuator in the front housing.

The rear window wiper motor on a 2001 Chevy Tahoe is changed by removing the inner trim and disconnecting the wiring harness. The mounting bolts and wiper arm can then be removed and a new motor installed.

throttle STICKS, when in gear the motor races and don't go ?

Yes it will as long as it is the same size / cubic inch.

It is recommended to use 10 W 40 motor oil in a 2003 Chevrolet Tahoe engine. It is also recommended using 10W-30 motor oil in a very cold climate.

it is behind the right plastic panel in the cargo area

Blower motor is going bad. They are usually behind glove box area.

Yes. It prevents the motor from from turning over while in gear.

Bad fuse (open), bad switch or bad blower motor.

Try drilling a very small hole at the rear of the motor to lubricate the bearing

It is on the top of the motor on the drivers side and it has a hose on the top of it. It just pulls out pretty easy.

No , it is NOT an interference engine ( according to Gates - they make timing belts etc. )

It is on the top of the motor on the drivers side and it has a hose on the top of it. It just pulls out pretty easy.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.