Yes a head wind and flaps set to mid for wing configuration
No, wind is not required for a plane to take off.
No. An aircraft takes off and lands into the wind. (Or as close as possible to directly into the wind).
It then produces lift due to wing configuration and can take off
If conditions (airport layout and traffic conditions) allow aircraft take off and land against the wind (headwind). This way the aircraft can take off or approach the runway at a lower ground speed.
Depends on the airplane. Every aircraft has different specific guidelines for altitude, velocity, max wind speed and weight, as well as many other limitations.
Yes, however it is considered an electronic device and you will be required to turn it off during take off and landing sequences. Yes.
Aircraft always try to take off and land INTO the wind, as the effect of the wind flowing over the surface of the wing increases lift and therefore reduces the speed necessary to perform a take-off/landing. For example, if an airliner has a computed take-off speed of 130knots, but there is a 10knot wind blowing directly at the aircraft during the take-off roll, the airliner only needs to achieve 120knots as the 10knot wind provides the extra to reach the required 130. Of course it is rare that the wind will be blowing in the exact same direction as the alignment of the runway, which is why major airports have several runways, pointing in different directions. If there is just a single runway, aircraft may have to land or take-off in cross-wind directions. This can affect the control of the aircraft but safety dictates the maximum amount of cross-wind before it is deemed unsafe to land - usually in excess of 40knots.
This varies greatly from airplane to airplane, as well as according to ground wind conditions. Keep in mind that landspeed does not matter to an airplane nearly as much as AIRspeed. For example, your typical 4-seater single engine airplane takes off at around 60mph airspeed. Given a 20mph headwind, this aircraft could take off at 40mph GROUND speed. If you are interested in how fast the ground is wizzing by when youre looking out the window of the airliner. Most airliners take off at around 150 to 180 mph AIRspeed.
An airplane flap extends the wing area during take-off and landing, to give extra lift at low speed. This allows the airplane to take-off and land at reasonably low speeds (around 150mph for most jet airliners).
That is a 'crosswind'.
It was not an airplane, and thus could not take off.
no it cannot take off if it is going slow
The wind is required to pass over the wing to create a vacum which lifts the plane. Flaps are used to extend the wing surface to help with lift