answersLogoWhite

0


Best Answer

Is it a diesel? If no then disregard the following. If yes then NO ETHER! Its very damaging to this engine. Never use it. If this motor and its electronics are functioning properly it will start down to 0 or maybe less all by itself and even easier with the block heater plugged in. Make sure you have fuel reaching filter. Open petcock and purge fuel bowl. Be sure filter is in properly and resealed with big O ring (You may want to partially fill the bowl with fresh fuel first but usually isn't necessary) Check all your fuses under hood and under dash...every one of them! Plug in the block heater for a few hours even if its 40 or 50 degrees out. Switch to other fuel tank and treat your fuel with a half quart of 911 treatment per fill up in each tank (below30 degrees). You may need glowplugs replaced or the relay for them. This is a very forgiving engine but don't push your luck. Be patient, do your Prev. Maint. and talk nice to it and it will last nearly forever. Mine has 233,350+ m. and all original and runs as good as the day I bought it , 15 to 20 mpg. Best truck/motor ever paired together. good luck 1996 F-350 7.3LPSD owner

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Won't start 1996 F350 replaced fuel filter and started with ether?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

89 350 5.7L wont start without ether when cold When truck is running and hot it runs great everything seem to be working fine you replaced the fuel filter coolant temp sensorand no OBD codes showing?

Check the timing.


How do you get a 2009 npr started after replacing fuel filter?

To get the 2009 NPR started after replacing the fuel filter, simply start the engine.


What to do if Chevy astro does not start?

i replaced the steering column and the fuel filter. the radio was stolen


How do you get your Hyundai accent started after changing the fuel pump?

It should start with no problems if you have done everything right. If it does not then use some starter fluid to get it going. Make sure you also replaced the fuel filter.


1999 surburban replaced fuel filter not doing the job what is best fuel filter to use?

What do you mean by not doing the job?? Do you have a loss of power, wont start?


Why wont your duramax start after you replaced the fule filter?

If you didn't fill the new filter up with clean diesel fuel when you assembled it, you introduced air into the system.


You changed your fuel pump but your 98 Chevy s-10 still wont start why?

was fuel filter replaced


I have a 2000 Chevy Tahoe that wont start. I have replaced the fuel pump and filter. It wont start especially if it is cold. I spray some ether in the air filter and it will start. How do I fix..help.?

Could be several things, Crank sensor on distributor, bad oil pressure switch, bad computer. If you cycle the key on then off, do you hear the fuel pump run? When you try cranking the engine what is the oil pressure gauge at 350 Vortec engines require 20+ psi oil pressure to trigger the distriuter to fire.


95 wrangler won't start sometimes replaced fuel pump and filter but still stalls and then won't start Wiring problem?

Maybe a O2 censor.


Have replaced fuel filter and fuse is good what else could it be car won't start on a 93 buick century?

hello how are you?


Kohler cv675s engine that will start but only run for 2-3 seconds Have replaced fuel filter and pump What next?

Check your Carb. Have had problems the float needle valve. Black particles stopping the valve (seemed to have started when we went to 10% Ethanol).


Diesel fiesta taking three or 4 turns of key to start changed fuel filter what do you check next think glow plugs are ok?

if this a cold weather start, u need to either use a block heater to keep engine warm,park in a shed, or give a 2 second squirt of starter fluid(ether) into the air cleaner before ya try to start if ether makes it start quickly it is cold weather problem