With increasing torque load the armature tends to slow down; the motor draws more current to compensate, and if there is armature resistance the back emf generated by the armature falls to allow the increased current to flow, which causes the motor to settle at a lower speed.
The mechanical output power is the speed times the torque, and increasing the torque increases the power output provided the speed does not drop much.
obtain experiment speed control of D.C shunt motor by Varying field current with armature voltage kept constant
Increasing the voltage by 1% also increases the field current by 1%, so the back-emf increases by 1% without the speed changing. Therefore the motor speed stays the same.
shunt motor speed is almost keeps constant.
UiTM...are u?
critical.
Increasing the armature voltage would increase the speed. In a separately excited dc motor the speed adjusts so that the back emf generated by the armature is a little less than the supply voltage. The difference, divided by the resistance, gives the current drawn, which is also proportional to the shaft torque supplied to the load.
yes
when you put your ac directly on your dick then it is proportional. not a ac voltage
pogi current flow in the armature conductor
Yes, because as the armature voltage increases, the speed also increases so they are proportional.
The armature voltage is a critical parameter in the determination of performance characteristics for the DC machine. The armature voltage has been shown to be proportional to the magnetic flux density per pole and the armature speed. Thus, the armature voltage will also exhibit nonlinear behavior when saturation occurs. The analysis of DC machine performance typically requires that the characteristics of the armature voltage saturation be known. This information is typically provided in a plot of the armature voltage vs. field current (magnetization curve) for a given operating speed
The induced current is proportional to applied voltage. i is proportional to v Or you might say, "A current source drives a fixed current through a circuit. Then the voltage developed is proportional to i" . Both forms are equally correct. Voltage sources are more common than current sources so the first form is more common.
critical.
if there are magnets on the stator and the commutator is phased properly this is known as a permanent magnet dc motor the starting torque is dependent on armature current and the strength of the magnet the speed is directly proportional to the armature voltage a shunt motor needs the field energized for starting. more field more starting torque
The motor needs the current and magnetic flux to create motion The magnetic field is created by field winding where as armature carries the current resulting into the rotation of armature
Increasing the armature voltage would increase the speed. In a separately excited dc motor the speed adjusts so that the back emf generated by the armature is a little less than the supply voltage. The difference, divided by the resistance, gives the current drawn, which is also proportional to the shaft torque supplied to the load.
For any dc shunt motor the speed is directly proportional to the armature voltage. hence if you vary the armature voltage by any means( using thyristor ) or static converters using conventional method( ward Leonardo system) surely you can increase or decrease the speed of the shunt motor. Manjunatha M
yes
Generator output is controlled by voltage feedback to the voltage regulator which senses voltage drop or rise and regulates the current being sent to the armature. This rise and fall of the armature current governs the generators output voltage.
The excitation system is used to control the excitation of the rotating field in the armature. By increasing the armature current, it in turn increases the magnetic flux in the armature coil. This has the effect of increasing the voltage output of the generator. By lowering the armature current this in turn lowers the generator output voltage. The generator's voltage regulator automatically adjusts the output voltage continuously as the applied load on the generator changes.
voltage is directly proportional to resistance, and the current is inversely proportional to resistance. According to Ohm's Law, current is directly proportional to voltage.