0
Would new transmission fluid keep your 1990 300zx non turbo from clunking when letting off the gas The clunking happens when you step on the gas and when you take your foot off the gas.?
Wiki User
∙ 17y ago
Check your U joints, clunking is always a good sign that they are going bad. try this, hold the brake and cycle the transmission into reverse and listen for the clunk, still holding the brake cycle it into drive. If the u joints are bad you will hear it each time the transmission engages.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Can you put a 350z engine and transmission in a 300zx?
Yes my car is a 1990 300zx with a 2008 350z motor and 6speed transmission
Will a 1984 Nissan 300zx engine and transmission bolt into the 1986 Nissan 300zx?
Yes it will
Will Chevy 400 small block bolt up to 1990 300zx transmission?
A Nissan 300ZX? No
Why is your 300zx transmission slipping?
It could be a bad clutch.
What side is the transmission on the 1992 300zx?
It's actually in the center.
What transmission fluid is used for 1985 300zx?
The FSM calls for a 'Dexron' type transmission fluid.
How do you put in transmission fluid in a 300zx?
There are two plugs on the 300zx manual transmission. on on the passenger side and one on the bottom of the transmission. You can unscrew them with a 1/2 drive ratched. fill through the plug on the side, drain from the plug on the bottom
Where is the starter located on a 1991 non turbo 300zx?
next to the transmission
Will a turbo 350 transmission fit a 300zx twin turbo?
Your and Idiot.
Where is the starter on a 1990 Nissan 300zx?
On the underside, passenger side, of the transmission.
Where is the slave cylinder located at on 86 300zx?
it is located on the side of the transmission
Where is the inhibitor switch on a 1990 Nissan 300zx?
it is located on the transmission itself
