The components you didn't mention for the ignition are;
1) ignition coil (converts low voltage (about 200-400V) to 20,000 volts)
2) Pickup coil (fires the charged-up capacitor in the CDI into the ignition coil)
By using the widely available wiring schematic for the Banshee, you can measure different components on the Banshee. Go to the forum at www.bansheehq.com for help from the guys there- you will not regret it.
You cannot get the banshee on the level Silent Cartographer without the use of mods. But because the Banshee is in the coding of the level Silent Cartogrpher, you can do a scenario import, which is why there are many mods out there that have a banshee in that level.
A banshee will shriek and wail as a premonition of a coming death. Traditionally, they were (are) Irish. In Irish folklore, banshees are female spirits who wail to warn of impending death. Please see the related link(s) below:
PLEASE HELP???.... PLEASE go herehttp://www.installdr.com/hope it helps
please be more specific. what year, what model? schematics for wiring harness 2001 soft tail motorcycle
That would be banshee. In Irish folklore a female spirit who wails to warn of impending death. Please note the word folklore, meaning the unwritten lore (stories and proverbs and riddles and songs) of a culture.
Go tohttp:/www.kiatechinfo.com Register/Login This gives access to Kia Factory service info, schematics etc
you have to GUIDE the banshee though the tunnel, (yes through the enemies) and kill the marines because they will destroy it. oh yea, keep a CLOSE eye on it because it will disappear. and when it says "Checkpoint Saved" or something like that. and then you can ride it freely :) (but it says checkpoint saved when your going outside of that tunnel)
under the hood The wire for the horn is part of the front lights wiring harness. The relay is not under the hood. Please, if someone knows, where is the horn relay?
To determine which wires to join on a 1980 or 81 4500 citation motor after cutting out the harness, it is best to locate a manual or see a qualified mechanic. Electrical work like this is always best left to a professional.
look for orange wire harness exiting bottom of column. disconnect connector. measure resistance of the pellet in your ignition key. write down that measurement in ohms. go to radio shack or a store that installs car alarms and buy a resistor to match ohm reading of ignition key. install this resistor on wire harness side (oppisite steering column harness)of that orange wire harness exiting bottom of steering column. it will have 2 wires inside of it. DO NOT WORK ON YELLOW WIRE HARNESS, THIS IS YOUR AIR BAG, YOU DO NOT WANT TO ACCIDENTALLY SET IT OFF!
The trailer wiring harness diagram and instructions can be obtained from most auto-parts stores. The diagram and instructions can also be found at many travel trailer dealerships.
Please give more information....it connects to the fuel pump from there it goes into the trunk,travels _under_the back seat passenger side where there is a connector,from there it connects to the interior elect. harness