0
You are installing an aftermarket stereo in your 1998 GMC Suburban and everything works right except the two rear door speakers you noticed when replacing the door speakers with brand new high end one?
Wiki User
∙ 15y ago
The GMC stereo has amplified rear door speakers. When wiring up the aftermarket stereo, connect the blue wire on a GM aftermarket harness to acc power and the speakers will work. I did the same thing for mine about 5 years ago.
Good Luck...
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you fix a sagging door on a 1996 suburban?
You can fix a sagging door on a 1996 Suburban by replacing the door pins and the bushings.
How do you Replace head gasket Chevy Suburban?
what is the preceger for replacing the head gaskets on a 1993 chevy suburban 4x4 350
Replacing a timing chain.?
How to replace a 1985 Chev Suburban's timing chain
Will replacing the blower motor resistor in the 1997 suburban correct the air output?
Replacing the 1997 Chevrolet suburban blower motor resistor can correct your air output issue. The air output issue could because by other things.
Why does sound cut out in 2002 suburban aftermarket stereo?
im sorry but i dont have a clue i hope you find out soon because idonthave a clue slan
Installing drivers window 97 suburban?
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
Chevy 1990 Suburban master brake cylinder help?
If you are replacing make sure that you bench bleed prior to installation
Why does everything work but your brake lights on a 95 Chevy Suburban?
If a 95 Chevy Suburban's brake lights do not work but everything else does, it may be the link that connects to the pedal that has a problem. If the pedal has been adjusted or disconnected, it may also be a reason for the issue.
Your backdoor speakers on a 96 Chevy Suburban will not play after installing a aftermarket stereo?
if the radio is used check to see if the radio rear outputs are working. make sure fade is equal to front and back. if it is a pioneer radio make sure that rear preouts are set to full and not sub. the amp made need to be bypassed. these are just a few options need more details to solve problem
I am replacing the intake manifold on my 1999 suburban and in taking apart the distributor cap what is the white film inside?
Possibly lithium grease or condensation
How do you reset the check engine light on 03 Chevy Suburban after replacing the oxygen sensor?
disconnect the negative battery cable for 30 seconds
How much should replacing the starter in a 1999 Chevrolet Suburban cost?
$40.00 labor. Starter may cost anywhere from 120.00 to 145.00
