well my abs light was on cause i needed brake fluid..... If you do need to read the ABS codes, the module is under the panel next to the rear passenger seat. This is an OBDI car not an OBDII car.
most likely because you have no oil in your engine check it i change the oil i went to mechanic he check the oil but light showing .
No.
Yes, that is one of hundreds of possibilities.
Yes, that is one of hundreds of possibilities
The Integra uses a dual-filament bulb in the tail light, which has one contact for the running light (the lights you turn on at night) and another brighter one for the brake light (only goes on when you press the brake pedal). You have replaced the bulb with the wrong type. You will need a 2057 bulb for the Integra.
The check engine light could any number of things. It is impossible to know what the light means without having the car checked by a mechanic. The mechanic will then be able to tell what is wrong with the car.
i am pretty sure there are no daytime running lamps on a 90' integra...
It could be an alternator. Check with a mechanic if that is the issue.
The best way to reset the engine warning light on a Nissan Primera p12 would be to take it to a mechanic. It is best to have a mechanic check it out to make sure nothing is wrong that could malfunction and put someone in danger. The mechanic will be able to reset the engine warning light.
The brake light fuse on a 1995 Acura Integra is located inside the cabin of the vehicle. It is on the same circuit as the dash and hazard lights.
Usually when the D4 light flashes it means there is a tranny problem.
2007 should still be under warranty but, try an OBD-II scanner. this will give you more specific details on what the light means. There are a number of codes that could be displayed, anyone of which could trigger the dreaded check engine light.