Go back top the shop and ask them to help.
No. A straight line on a mercator map is a path of constant bearing, but this will not generally be a great-circle route.
Rod bearing (short for connecting rod bearing) Is the bearing where the connecting rod is attached to the rotating crankshaft.
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
It is a bearing (a direction) based on a magnetic compass reading.
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
Bearing Straight was created in 1989.
no
The drivebelt may be slipping, or a roller bearing dried out.
the bearing of something is the angle. for example there are 180 degrees on a straight line so the bearing of a straight line is 180 degrees. To work out the bearing of something though you need a protracter
Depending on the sound, it could be a slipping belt or a worn pulley bearing. A slipping belt is typically caused by a belt that needs adjustment or by a weak idler spring. A worn pulley bearing can be any of a number of things, the bearing on an alternator, an idler pulley bearing... who knows until you get into it. Also, sometimes a worn heater motor will make a terrible noise when it's cold, as can a radiator fan motor.
If its slipping you will smell it. If it shutters you probably have grease spots on your fly wheel. Grinding noise may mean you need a new pilot bearing(throughout bearing).
Assuming the tensioner is keeping the belt tight, you need to make sure all of the pulleys are still in a straight line. If a bearing has failed in a pulley the puley will "lean" causing the belt to run off the edge.
Make sure the hole in the bearing is aligned with the hole in the block. Use a cam bearing installation tool to get the bearing straight.
Everybody has individual pain thresholds, so it could go either way for you. Regardless of how you find it, however, it's worth bearing in mind that it's just a few seconds of pain for a beautiful new piercing.
Glazed or slipping belt? bad bearing in belt driven accessory? i.e. alternator, water pump, etc.
If you have put it into gear and the car is not moving either your clutch is slipping or your clutch realese bearing is gone
Belt slipping? Bad bearing in belt driven accessory?