0
You have been using a straight barbell for your frowny piercing since you pierced it about a couple of years ago and now you cant seem to remove it the ball bearing keeps slipping out of your grip hel?
Wiki User
∙ 14y ago
Go back top the shop and ask them to help.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Mercator projection maps are used to determine great-circle routes?
No. A straight line on a mercator map is a path of constant bearing, but this will not generally be a great-circle route.
What is a rod bearing?
Rod bearing (short for connecting rod bearing) Is the bearing where the connecting rod is attached to the rotating crankshaft.
How AC compressor clutch bearing?
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
What is magnetic bearing?
It is a bearing (a direction) based on a magnetic compass reading.
What is the recommended torque setting on Honda Accord rear wheel bearing?
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
When was Bearing Straight created?
Bearing Straight was created in 1989.
Did Prince Albert have the famous piercing bearing his name?
no
Why has your Dyson vacuum started screaming at you?
The drivebelt may be slipping, or a roller bearing dried out.
What does bearing mean in maths?
the bearing of something is the angle. for example there are 180 degrees on a straight line so the bearing of a straight line is 180 degrees. To work out the bearing of something though you need a protracter
Why when its cold outside your car squeals when you start it?
Depending on the sound, it could be a slipping belt or a worn pulley bearing. A slipping belt is typically caused by a belt that needs adjustment or by a weak idler spring. A worn pulley bearing can be any of a number of things, the bearing on an alternator, an idler pulley bearing... who knows until you get into it. Also, sometimes a worn heater motor will make a terrible noise when it's cold, as can a radiator fan motor.
What are the symptoms of a bad clutch in a 2003 Chevy cavalier?
If its slipping you will smell it. If it shutters you probably have grease spots on your fly wheel. Grinding noise may mean you need a new pilot bearing(throughout bearing).
Why would the serpentine belt on a 1994 Le Baron keep slipping off of the pulleys?
Assuming the tensioner is keeping the belt tight, you need to make sure all of the pulleys are still in a straight line. If a bearing has failed in a pulley the puley will "lean" causing the belt to run off the edge.
How do you position the cam bearings on a 350 Chevy engine?
Make sure the hole in the bearing is aligned with the hole in the block. Use a cam bearing installation tool to get the bearing straight.
Does a navel piercing hurt more or less than a lip piercing?
Everybody has individual pain thresholds, so it could go either way for you. Regardless of how you find it, however, it's worth bearing in mind that it's just a few seconds of pain for a beautiful new piercing.
What is that Squeaking sound coming from the engine at start up?
Glazed or slipping belt? bad bearing in belt driven accessory? i.e. alternator, water pump, etc.
Why the engine sounds like it's getting gas but the car does not move?
If you have put it into gear and the car is not moving either your clutch is slipping or your clutch realese bearing is gone
What is wrong with your 96 Mazda miata mx 5 you have replaced tightened both belts and there is still a loud squeal?
Belt slipping? Bad bearing in belt driven accessory?
