answersLogoWhite

0


Best Answer

Re open the switch junction box after turning the power back off. If you can locate the wire that bring the voltage to the box make sure that this wire goes to the top of the switch. If it is tied into more black wires this could be receptacle circuits that are on all of the time. If this is the case, from this group add a pigtail from this group to the top of the switch. from the bottom of the switch find the wire that is going to the light. It is probably in the group that is tied together. Once found terminate this wire to the bottom of the switch. Put the breaker back on and try the switch.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: You have just replaced your ceiling light and when you turned the power back on the light stays on even when you turn off the switch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

Why do ceiling fan lights go out?

Without knowing some more facts, there could be several different answers to explain why a ceiling fan's lights "go out":someone has turned them off at the switch for the lights on the fan unit;the light bulbs are "dead" and need replacing because their filaments have broken;there is a fuse protecting the lighting circuit and it needs replacing because it blew from the surge of high current that sometimes happens when a light bulb "dies";there is a timer in the fan unit which turns the lights off after a certain period of time;the wiring from the switch to the light has become disconnected;the switch in the fan that controls the lights is broken and needs to be replaced...


How does power continue to a light if the switch is turned off?

plug it in


To mount two switches and a pilot light in a single gang standard device box you would use?

You would need to purchase a duplex switch. As for the pilot light look for a duplex switch that has a neon pilot light that is incorporated into the handle of the switch. When the switch is turned on the switch's handle will illuminate.


If a light switch that is connected to an outlet which is burnt out and when you replaced the outlet it burnt out within two weeks so how do you change the switch to operate recessed ceiling light?

you must have to much of a load on the outlet or didnt tighten the screws holding the wires tight enough , it should not go out that quickly. if you want to wire it for recess you first have to check if you can get to the location in the attic above the switch. and you need to be able to fish a wire down to the switch up to the recesed lite. which sometimes is not the easiest job to do , better to just call in the electrician for this job


Feed drops to zero volts when light switch is turned on back to 120 volts when turned off feeds fluorescent lights?

voltage is measured by voltagd drops. When a switch is open/ off there is a voltage difference between one side to the other. when the switch is on there is no drop from one side of the switch to the other. That is normal operation. If switch is on, and you get a voltage reading across the switch, the switch is bad.

Related questions

Where is expedition light switch on rear hatch?

The light switch is located above the hatch door ceiling.


When a light switch is turned on what travels through the wire?

Current flows through a wire when a light switch is turned on.


Can I get my ceiling fan to turn on and off by using the light switch?

Yes. Simply turn on the ceiling fan while the light switch is in the "on" position. Adjust the spinning to the level of your choice. Now the fan will turn on and off when you switch the light on and off.


Why does dimmer switch cause ceiling light to make noise?

.


How do you fix a fluorescent ceiling light that lights up seconds after the switch is turned on?

Try moving the tube in the fittings, if this doesnt work, then you probably need a new starter motor.


Where is the dome light switch on a 2004 Saturn Vue?

On the centre of the ceiling (light for rear section)


When a light switch is turned on what is done to the curcuit?

When a light switched is turned on the circuit is usually closed.


Why does a light stay on after switch is turned off?

Either the switch is broken or it doesn't go to that light.


What could be wrong wit the door light sensor on peugeot partner.I have replaced both and still no luck.?

Be sure the interior light over-ride switch is not turned off or the fuse is not blown.


Why do ceiling fan lights go out?

Without knowing some more facts, there could be several different answers to explain why a ceiling fan's lights "go out":someone has turned them off at the switch for the lights on the fan unit;the light bulbs are "dead" and need replacing because their filaments have broken;there is a fuse protecting the lighting circuit and it needs replacing because it blew from the surge of high current that sometimes happens when a light bulb "dies";there is a timer in the fan unit which turns the lights off after a certain period of time;the wiring from the switch to the light has become disconnected;the switch in the fan that controls the lights is broken and needs to be replaced...


What light indicators come on when ignition switch is turned on?

the radiator was replaced and the fluids are still evaporating or leaking out somehow. what other options could be wrong with the car overheating?


Why wont your interior lights come on when you open the doors in your 2000 Saturn LS?

The interior light switch on the ceiling of the car might have them turned off, or there may be some electrical short causing the problem.