0
You just replaced your radiator in your 1993 Grand Prix after filling with coolant and plugging up sensor the low coolant light is still on Whats the problem?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the proper procedure for filling the coolant system on a 1994 Chevy Camaro 3.4L?
This is difficult so pay attention- (1) Remove the radiator cap (2) Start filling the radiator with a proper mixture of water and coolant(Most climates us a 50/50 mixture) (3) Once the coolant reaches the radiator neck stop filling and let the coolant go down, you can speed this up by starting the engine and letting the coolant start to circulate. (4) keep doing this until the coolant level remains at or near the top of the radiator. Happy Motoring!
How do you top up the coolant on BMW e34?
The coolant is added by filling up the reservoir bottle. This model is not filled through a radiator cap.
1998 Plymouth neon espresso i keep filling up radiator?
You may have a coolant leak that will need repaired.
How do you add coolant to radiator in 1995 Chevy cavalier?
Open the radiator cap and pour coolant in. If you're filling an empty system, you'll want to leave the cap off, and run the engine for 30 minutes or so to 'burp' out any air in the system, then top your coolant off again.
How do flush radiator in 1999 cougar?
The radiator on a 1999 Mercury Cougar is flushed by draining the radiator, filling it with water, and adding a commercially available radiator flush. The engine is allowed to circulate for 10 minutes, drained, flushed with fresh water, and refilled with coolant.
Where do you add coolant to the radiator on a 2002 Ford Taurus?
Checking & filling coolant on the vehicle is considered routine maintenance, and is well detailed and illustrated in the Owners Manual - See "Related Questions" below for more
How do you flush the radiator in a 1999 Pontiac Grand Prix?
The radiator on a 1999 Pontiac Grand Prix is flushed by draining the coolant, filling the system with water, adding a liquid flush to the system, and running it for a few minutes. The system is then drained, flushed with fresh water, and refilled with coolant.
Why would a fan work only after the coolant has overheated on a 1994 3.3 Plymouth Voyager that has had the water pump and thermostat replaced?
1- Air bubble caused by improper filling technique. 2- Bad radiator cap. 3- Bad ECT sensor. 4- Something else.
Where is the radiator drain plug on a Mercury Mountaineer?
When facing the front of the Mercury Mountaineer, the drain plug is on the lower left of the radiator. Place a bucket under the drain plug spigot before loosening to catch the coolant. To empty the radiator, turn the drain plug three-quarters of a turn. Tighten the drain plug before re-filling with coolant.
How do you prevent coolant contamination?
by filling radiator or reservoir according to specs, no tap water, which contains dissolved calcium and other contaminants; and changing fluid at least by prescribed intervals.
How do you filling coolant?
Add coolant to the full cold line on the coolant reservoir when engine is cold.
What is the GM approved procedure for draining and filling the entire cooling system radiator and block for a 98 Pontiac Transport?
Hey Nancy==Simply remove the drain plugs from each side of the block and the bottom of the radiator. CAtch the old coolant and dispose of it properly. Refill the system with 50/50 mix of coolant and water. GoodluckJoe
