0
You keep blowing your no11 fuse in both your mark VIII that control the hazards and brake lamp and brake pressure switch?
Wiki User
∙ 13y ago
unplug the neon light and see if that stops it
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Will a bad oil pressure switch cause the ecmb fuse to keep blowing on your 92 s10 blazer 4.3 liter?
NO.. It will not.
What is an air pressure switch used for?
An air pressure switch would control the air pressure in any machinery that relies on air pressure for functioning. These switches can be found in any industrial facility.
What happens when your Switch is bad on your 97 Air conditioner?
You need to specify WHICH switch you're talking about... Low pressure switch? Fan control switch? What?
What is a water pressure switch?
A water pressure switch is commonly used to control a well pump. The switch is installed at the pressure tank and when water goes out of the tank pressure drops . When pressure gets to 30 psi that's usually the setting for the switch to activate the pump. The pump will come on and run for 2-5 minutes replenishing the tank to 50 psi then the switch will turn it off. (some systems are 40-60, but 30-50 is common)
My dodge heater blower control only works on low what might be the problem?
Dodges are good for blowing fuses. If that is not it, the fan switch might need replaced.
Why would my turn signals flash fast on a 2001 Chevy express van but my hazards work fine. replaced multifuncion switch and headlight switch?
check out the flasher itself some are set to flash faster than others,switch out the hazards with the turns and see if hazards flash fast.
Pressure switch adjustment?
This depends on what pressure control valve you have and the switch that comes with it. Some may be adjusted, others not, check for a small knob that you can check for pressure adjustment, best way to do this would be to open a tap (faucet) and then turn the adjustment knob down or up to the required pressure.
What is the name of the sensor that is connected to the brake pressure control valve in a 1993 Lincoln Mark VIII it is leaking brake fluid?
cruise control switch
Where is the oil pressure switch on a 97 gmc z71 and could it have anything do with blowing the ecm-b fuse?
to find the location try going to www.autozone.com and check on vehicle specs.
Your compressor will not shut off?
The year, make and model would be very helpful but check the following..................... 1. Pressure switch. 2. Pressure switch harness. 3. Clutch air gap. 4. Control panel.
Why am I blowing oil filter seals on my 87 3.8 buick I noticed I was running about 80 lbs pressure wcih seams hi What does an oil pressure switch do?
Are you using the right amount of oil? Check your repair manual. because the oil pump is a gear pump it can easily create too much pressure since oil is non compressable and rotary pimps are positive placement. Also your oil switch indicates low pressure. That oil light you see when you first turn your key is activated by the oil switch and should turn back off after a few seconds. If that light stays on and your blowing seals then you should call an excersist.
What if your blinkers and hazards do not work on your 1992 Toyota pickup?
If both blinker and hazards dont work check your flasher switch.
