0
What if your blinkers and hazards do not work on your 1992 Toyota pickup?
Wiki User
∙ 16y ago
If both blinker and hazards dont work check your flasher switch.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is going on when the blinkers all of them quit working but the emergency flashers work for a 1992 Toyota pickup?
you need to replace blinker can in your vehicle. the flashers and blinkers have separate flasher cans which is why your flashers still work but not your blinkers
What does it mean when the front and back blinkers and the hazards do not work on a 1992 Toyota Camry automatic 4cyl 2.2?
probably a bad emergency light flasher - NOT a turn signal FLASHER- IF the FUSES are good .
Can you replace a 1990 Toyota pickup motor with a 1992 Toyota pickup motor?
depends on what motor is in both of them are they both 4cyle or 6cyle
How hard is it to change the rear main seal in my 1992 Toyota pickup 3.0 V 6?
How hard is it to change the rear main seal in my 1992 toyota pickup , with the 3.0 V6
How much does it cost to change the clutch in a 1992 Toyota pickup?
It can cost up to about 2000 dollars to replace the clutch in the 1992 Toyota pickup. This varies with the type of parts required and with where you are located.
Where is the backup light switch on a 1992 Toyota pickup?
inside the tranny
What is the best octane level fuel 1992 Toyota pickup?
What octane of gas should I run in my 1992 Toyota pick up 22re
How do you replace the windshield wipers on a 1992 Toyota pickup truck?
replaceing windshield wipers toyota truck
Were is the fuel pump relay on a 1992 Toyota pickup 4x4?
were is the relay for 4x4 fuel pump 1992
Where is the fuel injector relay located on 1992 Toyota pickup?
Where id the fuel injector relay located on a 1992 toyota camery 4 cylender
Can you swap aV6 for a 4 cylinder in a 1992 Toyota pickup 4x4?
shudafup
Where is the speed sensor located on a 1992 Toyota pickup?
in the right side the transmission
