0
You own a 1997 C230 with 99000 miles It has a problem with starting consistently you had the ignition assembly replaced and tried a new key. The battery and plugs have been checked.?
Wiki User
∙ 14y ago
Try diagnosing the starter
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does your Oldsmobile alero hesitate before starting?
you need to re-do the timing of the ignition system. the other possibility is the ignition is worn out and needs to be replaced.
Is this normal that the ignition key spinn before starting the BMW 235 i 1995?
It is not normal because that is a common ignition failure. This is can be caused by a broken lock pin in cylinder assembly.
What causes the ignition switch to rotate without powering up the ignition system and not starting on a 1984 Chevrolet pickup with tilt steering?
If your battery is fully charged and the connections are clean and tight, the problem is probably that the contacts in the switch are corroded or worn, meaning your ignition switch will have to be replaced.
How to fix my 92 Cadillac Seville it keeps informing you starting disable wait three minutes?
the ignition switch is bad. you have to replace the ignition switch and you will have to have a new key made with it. i just replaced it in my 1992 seville. that will solve your problem.
Why does my car start after jump starting but then dies?
Probably the alternator is bad. Once the jumper cables are removed, there is no source for ignition if the alternator is bad. Have it tested and replaced if necessary.
93 probe gt replaced mass airflow sensor car turning over not starting replaced distributor and wires - any suggestions plan to pull codes this evening?
Check condition of ignition coil. Replace if bad.
How do you get the key out of the ignition on a 1989 Grand Prix when the key will not come all the way back to the off position?
According to other sources I have found in researching this question on the web .. the problem is most likely the Shift Lever Assembly. From the MSN Site:"An occasional problem with this vehicle is the Shift Lever Assembly (Transmission Shift Lock Actuator), automatic transmission only, and the Ignition Lock Cylinder Assembly. A failure of the Shift Lever Assembly will prevent the Ignition Key from being removed from the Ignition Lock Cylinder. Failure of the Ignition Lock Cylinder may prevent he vehicle from starting. The cost to repair the Shift Lever Assembly is estimated at $73.00 for parts and $71.50 for labor. The cost to repair the Ignition Lock Cylinder is estimated tat $21.54 for parts and $39.00 for labor. All prices are estimated at $65.00 per flat rate hour and does not include diagnostic time and applicable taxes.
Why won't a 1987 Nova 4-cylinder restart for a couple of hours after starting?
If my memory serves me right the ignition coil needs to be replaced. It has a tendency to get hot when it is not working properly.
What are the Components of the starting system?
Battery, kickstarter, ignition, ignition coil,
2001 Kia sephia with an intermittant starting problem Sometimes the startere just ticks and then sometimes it starts I replaced the starter and battery both Why?
I have just came up on this same problem with my 2000 Kia. Turns out it was the Ignition switch. $160.00 to have it replaced.
My 2000 Pontiac Sunfire 2.2L isnt starting I've replaced several relay fuses for the blower and ac. I found out that there is a recall on my ignition switch for my car could that be the problem or not?
A faulty ignition switch can certainly prevent an engine from starting. Before wasting any more money, take the vehicle to the dealer and see what they'll do about the switch.
What are the components parts of starting system?
Battery, kickstarter, ignition, ignition coil,
