Generally when the head gets replaced you would also want to replace your plugs as well. It can sometimes be a result from where the water has traveled into the oil from a bad head. I replaced mine with bosch platinum 2 and haven't regretted it for 2 years.
You can not. Chrysler did not put a key cylinder disarm switch on that vehicle.
ummm... I don't think you can. And what would be the point? A bitchy letter without sounding bitchy? Isnt the point to sound bitchy?
Air in a brake line or a bad master cylinder could cause this. Bleed the brake lines if you have been working on any brake cylinder. If this happened without any warning, the master brake cylinder is probably the cause and should be replaced.
Missing Without You - 2009 was released on: USA: 13 April 2009
try unlocking it from the driver side...the chip in the key should keep the alarm from sounding...it works for my sportage...
To replace the valve stem seals with the head on you must bring each cylinder up to top dead center, pressurize the cylinder with an air chuck screwed into the spark plug hole. (this prevents the valves from dropping into the cylinder) Now the seals on that cylinder can be replaced. The process is repeated on each cylinder. Note: you must prevent the engine from rotating when the cylinder is pressurized.
The fuel pressure regulator has one bolt holding it in place.l
Yolk, as in the yolk of an egg. It is perfectly proper to pronounce it without sounding out the "l".
WikiAnswers does not provide instructions for performing criminal acts.
what do you mean "sounding stupid"? just simply submit a request and state the reason why you want to be in the group if necessary -myspace.com/hipsterface ________________________________
False - its about a FBI missing persons unit
Just tell him. The worst he'll say is yes. :)