after you reconnect the battery you need to reset the alarm system. there should be a reset button (valet button) located under the drivers side of the dashboard. hold the button for 3 seconds then try to start the vehicle.
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
When using battery cables to start a car, once it has started is there a procedure when removing the cables from the running car?
With booster cables
My battery went dead. I am trying to jump start the 97 landcrusier and the alarm is going off. I did not set the alarm The car sat in the garage for two weeks and battery is dead. Alarm is set and I need to get it of to start the car via cables. help George We have a 96 Land Cruiser. The battery went dead and we dealt with the same problem when trying to recharge the battery. We discovered a toggle switch on the drivers side under the dash below the hood latch and gas levers. Flip that switch and you should be good to go. Apparently it resets the alarm.
Jumper Cables. If your battery has died, you may be able to use jumper cables to jump start it from some good Samaritan_Ü_s vehicle. If you can safely use jumper cables on your vehicle, make sure that the battery on the good Samaritan_Ü_s vehicle has at least as much voltage as your own.
Check the battery cables or starter.
Corroded battery cables. Remove the battery cables, negative first, and clean the cable connections and the battery posts. If that does not help the battery needs charging or is defective.
If the headlights will come on bright it's probably the starter. If the lights are dim it may be the battery. If you try jumper cables and it won't start it's probably the starter.
Bad battery.
Jump starting a Pontiac include jumper cables and another vehicle with a battery. A person will need to put jumper cables on each car battery to jump start it.
Battery or battery cables would be the first thing I would look at.Battery or battery cables would be the first thing I would look at.
Use battery jumper cables