If your exhaust pipes by engine get red hot you have a vacuum leak that will make it sluggish
I have an 87 Ranger and it is welded on.
They are welded in to the exhaust stream so as to prevent easy removal, its a government thing for the protection of our air quality.
if its already welded on you just slip it on theres no way of getting around not having a welding if that's what your asking
On Lycoming engines the exhaust pipes have a welded steel flange that seats over a copper gasket with 2 studbolts directly onto the outlet port of the engine.
This is one of the few applications where you are going to need to order your headers for that particular car. It is very tight and generic 350 headers are not going to fit. You will also probably need to have the collectors welded to your exhaust pipes to ensure you don't have exhaust leaks getting inside the car.
depends where the leak is comming from. If its the flex tube about $125,if its not really bad it can be welded.
Yes on the exhaust manifolds but the cat should either be welded or bolted on after your Y pipe then goes to your cat!
Depending on the location and size of the crack, you may be able to have it welded shut or you may have to replace the manifold.
there should be two (or four, if you have a dual exhaust set up). one just before and one just after the catalytic converter welded into/onto the exhaust. There will only be one, it is in the manifold on the back if the engine.
To repair a hole in a Borla exhaust try taking vehicle to a reputable muffler shop. Popular opinion states that having the hole welded will work but make sure the after market repairs are legal in your state.
There are multiple sensors on the vehicle. All are on the exhaust and are accessible from underneath the vehicle. They connect with a snap connector on the electrical wires, and the sensor itself is screwed into a half coupling that is welded onto the exhaust pipe.
The SRT-4 exhaust will fit, but it will need to be cut and re-welded near the front of the car where it goes to the exhaust manifold. In other words, it will take a bit of custom work and extra tubing, but the exhaust can be made to fit. The exhaust also does not sound very good on a stock neon since it only has resonators and no muffler.