I have a 1991 Chevy surburan and it has no tail lights and no dash lights, all fuses are good
The ctsy fuse is for your courtesy lights. These include your dome lights, vanity mirror lights, and any other small misc. lights in your truck.
YES. It is all the same. except the grill and lights but it will all interchange.
had that prblem, its your wireing hornis
Wiring lights on a Chevy truck is simple. All you have to do is color code the wiring and tape them together.
The load boards in truck stops, contacting freight brokers.. if you own a truck, and you don't already know this, you may want to consider instead hiring an experienced driver who knows what they're doing.
Check the fuses? Check the light switch?
You left some wires unplugged.
the old wiring is probly shot cause its an old truck. you should bring it to a mechanic to get it fixed
Check the brake light switch.
Bill's Chevy is the place to buy and used chevrolet pickup. There are loads to choose from. Love chevy they are tough and affordable. give it your best shot.
Dark Brown for all parking and side marker lights.
bulbs are to small Check the fuses.
3rd brake light or rear brake lights?
Check ALL the GROUNDS in the wiring harness and make SURE they are tight and clean.
The 2007 Chevy truck dash will bolt into a 1998 Chevy truck if both vehicles are the Silverado version of the truck. The dash is different for the lower versions of the interior options.
I have a 1990 Chevy 1500 truck the brakelight switch is disconnected and it has no connector going to it. I replaced all the bulbs. And still my running lights are in the on position when i turn off the truck. My brake lights are still not working after replacing the lights. I have a RV brake accuator also under the steering column can you help me solve my problem?
There is no such thing as a 310 Chevy truck.
No it will not.
No they will not.
have chevy chyenne 4.3L, truck runs great but have lighting problems, no headlights,breaklights or reverse lights, looked for fuse but none listed in box,checked for power at the switch plug all good but none at lamp, have parking lights, turn signals, hazord lights and tail lights....
frist remove turn signal/marker lights then remove grill from rad support.
Probably because the circuit board for the bulbs is rusted out at the bottom