If you are in 4LO, you will need to shift into neutral to go into 4HI and then you may press the 4x4 button to go back to 2WD. If you try this and the buttons are simply not working, it could either be the push-button system (sometimes they freeze up in cold weather) or the transfer case itself (try checking the fluid).
It will not disengage from four wheel drive until you find a cheat. I have done this before!
Passenger side floor, up under dash to the right of the driveshaft hump. Inertia switch is under the carpeting. Just push button down on top of switch to reset..
Well is it actually engaging into 4WD? If so, then you do simply have a problem with the lights. However, if you don't notice the transfer case engage, you may have a problem with either the push button system or the transfer case itself.
Look under the dash, in the center. It will be a black box with a white button. Just push the button back in.
Push the round key button in. You may have to insert the key first and turn to the right and than push the button.
No you need to put it in 2 high and remove the rear drive shaft.
most of them push buttons that I've had you always got to go in reverse after taking them out. if your in 4 lo you have to take it out of 4 lo first by holding the button in until t comes out.
With the engine running , and your foot on the brake pedal , shift to neutral , select 4x4 low and then put transmission in gear ( for use on surfaces that allow " slippage " such as gravel etc . ) To select 4x4 low the transmission must be in neutral to engage / disengage
depends on the year, manual or auto hubs, and lever transfer case or push button
On your dashboard there is a 4x4 button. push it. The hubs will engage and lock automatically. If you want low range you have to be in 4x4 first then you may push the low range button
The flasher control is located on the right side of the steering column near the dash. Push the middle button to engage. Pull the exterior sleeve to disengage.
in the trunk there is either a button or a little cable push or pull