0
Your 1995 Ranger Splash has a check engine light on indicating an evaporative purge valve malfunction Where is this valve located After repair how do you reset the light Thanks Dave?
Dziegler3
Hey Dave its right by the fuel tank and very easy to change you will need to go to a Ford dealer for the part but you can change it yourself, the only way to re-set the light is by computer that most local garages have they will probally charge you for that..
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is evaporative emissions purge control valve solenoid on 1999 ford ranger located?
above the rear end on the drivers side
How to reset computer on 2001 Ford Ranger?
The evaporative system needs to reset. How?
Over drive light flashes in your 2001 Ford ranger?
A malfunction has been detected
Why does a 1994 ford ranger check engine light conme on when engine warms up?
If the check engine light stays on , a malfunction with the emission control system has been detected , have your Ranger scanned for any trouble codes to diagnose and then repair the malfunction
Why is overdrive light blinking 2001 ford ranger edge?
a malfunction has been detected , get it checked out by a professional
What does it mean when the O D off light flashes on a 2002 ford ranger?
A malfunction has been detected
1992 ranger 3.0 v-6 why would the check engine light come on?
The check engine light comes on when a malfunction with the emission control system has been detected - if the light stays on ( and doesn't correct itself ) have the Ranger scanned for trouble codes to diagnose and then repair the malfunction
Why does an 87 ford ranger automatic transmission not grab when accelerating?
Sounds like an internal malfunction. Have it professionally serviced.
What would cause the overdrive off light to flash on a 2000 ford ranger?
A malfunction has been detected - get it checked out
How do you By pass securilock passive anti-theft system on 99 ford ranger?
You cannot bypass or reset the Securilock anti-theft system on a 99 Ford Ranger. If the system begins to malfunction and you can no longer start the vehicle, you will likely need to replace the transponder unit that is located behind the ignition in the steering column.
Why wont the engine shut off on your 1995 ford ranger?
I'm not a mechanic / technician but I'm guessing a starter relay ( solenoid ) malfunction ( located near your battery ) or a problem with the ignition switch Anybody else have any ides ?
What does it mean when the 4wd and 2wd indicator lights are flashing on the instrument panel of a 1999 Ford Ranger?
A malfunction has been detected
