answersLogoWhite

0


Best Answer

Probably a bad ignition switch.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 1996 jeep 4 liter will only run if ignition key is kept in the start position?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the cam position sensor on a 1996 Plymouth voyager with 3.0 liter engine?

The camshaft position sensor is inside the distributor.


Is there any adjustment to a crank shaft position sensor on a 1996 ford ranger 2.3 liter?

no


Where is crankshaft position sensor located on a 1995 Toyota Corolla 1.6 liter?

Where is crankshaft position sensor located on a 1996 Toyota corolla 1.6 liter?Read more: Where_is_crankshaft_position_sensor_located_on_a_1995_Toyota_corolla_1.6_liter#ixzz1nWxVCKMW


Ignition switch 1996 Honda passport is locked car will not start?

if the battery is dead the switch wont unlock or start


Where is the camshaft position sensor on a 1996 Chrysler Cirrus V6 2.5 liter?

It is in the distributor, you have to buy a distributor to replace.


Where is the camshaft position sensor located on a 1996 Chevy Silverado c-1500 5.0 liter engine?

it is in the distributor


2.0 liter ford Contour 1996 the car do net start battery is good the ignition coil and and timing plugs good fuel pup is good and the fuel is coming up well to the engine What would be the proble?

Did you check the altenator?


Why does 1996 Mercury Tracer's Ignition Switch lock-up and release only when shifter is removed from park position and replaced?

The ignition switch on a 1996 Mercury Tracer might lock up and release only when the shifter is removed from park and then put in the park position again because the sensor is getting worn. This sensor lets the ignition know that the car is in park and it is safe to remove the key. Check the shift position sensor.


How do you remove a key that is stuck from the ignition of a 1996 Dodge Caravan Steering wheel is not locked and cannot start the vehicle?

You can't, you have to replace the ignition switch


Why would a 1996 Plymouth Breeze 2.4 liter starts but shut off sometimes then be hard to start again starts then runs after temp rises to open thermostat?

I would check on the EGR. system, the valve and position sensor.


Key won't turn so can start your 1996 areo star ford?

key wont turnthe ignition


How do you remove and repair replace an ignition switch in 1996 1500 series Chevy truck that sticks in the off position?

call a lock smith .