Chances are this is the heater valve no longer functioning. This is located behind the plastic bulkhead panel at the back of the engine bay, under the bonnet. The valve will have 2 hoses (15mm approx) into and out of it Check you have power to and from the valve. If not rectify this fault first. It's a simple matter to replace the valve, drain enough water, remove hoses, unbolt valve, replace.
Disconnect the battery and drain the coolant.
You should check the thermostat and the fuse for the heater.
Should be at the engine end of the upper radiator hose
the radiator top hose, follow it, it should go on to a housing on the engine block which is bein held in by 2 or 3 nuts.
The replacing of a radiator in a 2006 Ford Fiesta should be done by a professional. There are multiple components around the radiator that, if accidentally removed or damaged, can cause further, more damaging damages to the vehicle.
check your water or coolant level If coolant level is ok, replace the thermostat.
If you have re-filled the coolant and checked for leaks no wait time is necessary
Yes, replacing the heater core should slove the problem.
there are no requirements for time periods on replacing machanical parts on a car it is simply when you need them. inspect regularly
If the car is overheating or if the temperature gauge is not coming up to normal operating temperature which is normally half way up the gauge then the thermostat needs replacing. As the water pump should be replaced at the same time as the cam belt every 90,000 miles, you should also replace the thermostat and coolant.If the car is overheating or if the temperature gauge is not coming up to normal operating temperature which is normally half way up the gauge then the thermostat needs replacing. As the water pump should be replaced at the same time as the cam belt every 90,000 miles, you should also replace the thermostat and coolant.
If the engine isn't getting over 140 F you have a failed thermostat.
Yes, but the good news is that you don't have to drain it all. Don't just let it pour out on the ground. Draining about a gallon should lower the level enough to replace the thermostat.