answersLogoWhite

0


Best Answer
Copy

ther is a switch in side the car on the brake pedel more than likely it is sticking if you lift the pedel the lights should go out ==More Info== The previous respondant is correct about the brake switch. It is located under the dash, behind the brake pedal's arm that comes down from the arm's pivot point above. The switch has a little spring-loaded plunger that the arm presses "in" when you put your foot on the brake. The switch has a threaded portion on the body with a nut you can loosen. I believe the switch has "disconnect-able" wires so you can pull it out for inspection, repair, or replacement. The plunger may be dirty or roughened up in which case you can clean and recheck for smooth action before returning it to service in your vehicle. If you have a continuity tester, you can check for continuity as the plunger goes in and out to make sure it's working right. There is one other possiblity, the body of the switch may be adjustable to make sure the brake pedal is going to be able to press it in when you brake and let it out all the way when you take your foot off. The threaded part of the switch may allow adjustment of the switch so the plunger is fully extended when the brake arm is at its normal return position. If the pedal is still pushing on the plunger when your foot off the pedal, then you may be able to adjust the body of the switch so that the plunger is allowed to fully extend when there is no force on the pedal. This will allow the switch to "open" and turn the brake lights off. ther is a switch in side the car on the brake pedel more than likely it is sticking if you lift the pedel the lights should go out

User Avatar

Wiki User

βˆ™ 2006-09-09 23:54:49
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How do you reset the computer in a dodge stratus 1998?

Scan tool or unhook the batteryScan tool or unhook the battery


How to reset the cd player in a Chrysler Sebring?

Unhook the battery for a few minutes.Unhook the battery for a few minutes.


How do you reset the computer for 1989 Chrysler lebaron?

You can use a scan tool, or unhook the battery.You can use a scan tool, or unhook the battery.


How do you reset a computer in a 2008 Chrysler Sebring?

You can use a scan tool or unhook the battery.You can use a scan tool or unhook the battery.


How do you turn off engine check light to Chevy cavalier after oxygen sensor is fixed?

Scan tool or unhook battery.Scan tool or unhook battery.


How do you reset the check engine light on a 2002 Chrysler Sebring?

You can unhook the battery or use a scan tool.You can unhook the battery or use a scan tool.


How do you reset computer on jeep liberty renegade 2004?

With a scan tool, or unhook the battery for 5 minutes.With a scan tool, or unhook the battery for 5 minutes.


How do you reset the computer on a 1997 Chrysler?

You can use a scan tool, or unhook the battery for ten minutes.You can use a scan tool, or unhook the battery for ten minutes.


How do you reset the computer on a 2004 dodge intrepid?

With a scan tool, or unhook the battery for 5 minutes.With a scan tool or by unhooking the battery.With a scan tool, or unhook the battery for 5 minutes.With a scan tool or by unhooking the battery.


If you unhook the battery in your 1994 acura legend should it stay running?

Why do you want to unhook your battery??? If the alternator is good the car will continue to run, if it dies then you have a bad alternator this is why you would want to unhook the battery cable to check and see if you have a bad alternator


How to reset the check engine light on a dodge caravan?

Fix the cause, use a scan tool, or unhook the battery.


How do you reset the computer on a 1996 Chrysler LHS?

Either use a scan tool, or unhook the battery for 5 minutes.Either use a scan tool, or unhook the battery for 5 minutes.


How do you reset the pcm or computer on a 1999 chrysler sebring?

You can either use a scan tool or unhook the battery for 5 minutes.You can either use a scan tool or unhook the battery for 5 minutes.


How do you reset a Kia Sedona check engine light?

You have to disconnect the negative battery for 5 min then unhook the positive then re hook the battery this should take care of the pesky engine light if it doesnt then u have to get the code


Do you need to unhook battery from car before charging?

No.


How do your reset a Dodge Stratus 2000?

Unhook the battery.


I replaced the ignition switch in a 92 f-150 and it cranks up but doesnt cut back off. Even with the switch off my instrument lights are still on unless I unhook the battery. Did I do something wrong?

probably. that or you pinched a wire creating a hot all the time wire.


How do you reset the radio on a dodge caravan 2000?

Unhook the battery.


How do you reset the service engine soon light on a 2000 Chevy venture minivan?

unhook the positive on the battery for 5 min. This should reset your check engine light if it doesnt then you still have issues.


What battery wire do you unhook first in a car battery?

disconnect the negative (black) first then positive (red).


How do you clear codes on a 1994 Saturn?

use a scanner, or unhook battery.


How do you reset a 2006 jeep computer?

Unhook the battery for ten minutes.


How do you reset a central timer module?

Unhook the battery for ten minutes.


How do you clear the codes on a 1988 jeep?

With a scan tool, or unhook the battery.


How can you temporary block your onstar when vehicle is being serviced?

unhook battery