EGR Systems
Chevy Camaro
Ford Explorer XLT

Your 95 camaro 34L would barely start and then stall when accelerator pressed engine trouble code indicated EGR Replaced egr and now idles high and still stalls?

012

Top Answer
User Avatar
Wiki User
Answered
2009-02-18 22:02:45
2009-02-18 22:02:45

clean iac sensor and o ring

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Diagnostic Trouble Codes.

He wont get in trouble because you are both underaged NO charges were pressed so again nothing can be done

I'm just a student of HVACR and I think a lack of refrigerant will be indicated by a warm an evaporator or the outlet end of the evaporator.

The control arm of a car needs to be replaced if the car is having trouble steering the front end.

no one pressed charges so how could u get in any law related trouble?

warning code check faults indicated by subsequent codes

po320 indicates acrankshaft position sensor problem should probably be replaced

Trouble code P1120 means: Accelerator Pedal Position Sensor Circuit Malfunction replace APS sensor Trouble code P01135 means: Air-Fuel Sensor Heater Circuit Response Malfunction

If your car breaks down the highway gently and smoothly take your foot off the accelerator. Do not ever try to break hard. Then after taking off your foot to the accelerator carefully work your vehicle toward the breakdown lane or the side of the road. If you can, signal the drivers behind you that you are having a trouble in that way you will avoid any collision.

Hi, I had a trouble myself initially finding it. The Fuse Box is located on the right side, Just above accelerator. You will have to literally sit on the ground with door open and look of a small white panel of about 4"x 2.5" on the right side above accelerator. I guess it would not be hard to detect. Cheers!

If the girl pressed charges he would probably be put on trial because she is a minor and not legally allowed to have sex

People are generally informed about emergency alerts by a telephone call. The person in trouble will have pressed their panic button and the call centre then phones a relative or close friend.

It can be done but it is not worth the trouble as you will have to take the steering rake out and fit a power steering pump and resivoir it is not worth the trouble as you will have to change the rake and fit a steering pump and resivoir

About $28-$45 depending on where you buy it. Then about $35- $70 to have the old bearing pressed out and the new one pressed in. You might want to check your CV shaft at the same time for $65 and a couple more minutes of time It might save you trouble 6 months down the road to change it.

possibly a bad cam sensor , i had problems with mine dying as well i replaced the cam sensor and have not had trouble since

It could be something as simple as a fuel filter that needs to be replaced or a weak fuel pump.

Trouble code P0463 means: Fuel Level Sensor A Circuit High Input

Pull the number one plug wire off and see if there is a spark from that to the engine. If there isn't then have your coil check or replaced


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.