there is an ABS siloniod located to the upper left of the brake pedal, under the dash you can check. Is the ainti-lock brake warning light illuminated on the instrument panel?
Which brake lamp are you needing to change? Brake/turn signal lamp.
NO brake light come on only when brake is applied the brake light is activated by a switch on brake pedal 2.Turn signal light is activated by your turn siganal lever which control a flasher that make tne light come on and off which is located around steering underdash you will reconize flasher by clicking sound silver small canister good luck
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
1993 Lincoln MKVIII turn signal and brake light bulb replacement: Purchase the correct replacement turn signal and brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal and brake light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Turn Signal / Brake Light Troubleshooting (check in this order): 1. Check Fuse 2. Check Bulbs 3. Check Flasher Relay 4. Check Turn Signal Switch in steering column and/or Brake switch down by brake pedal. Most likely its the fuse or bulb. See sources and related links below for bulb information.
If only the right rear brake/signal light is effected it is not the fuse. Inspect the right rear brake/signal bulb, socket and wiring.
The 1989 Lincoln Continental brake booster is located on the firewall in the engine compartment. The brake booster will be on the drivers side of the firewall.
In many cases, the brake light and the turn signal use the same bulb.
the turn signal handle is made to the multifunction switch. It operates the turn signals, brake light, emergency lights, ect. drl
the turn signal switch is probably bad
Where is the reservoir for the brake fluid
i have conected the black and red wire to the brake and it works (the brake light that is) and i conected the blue and white to the signal lights each wire being left and right signal and it all works. but when i brake all of the light lights up the red bar for the brake and the orage bars left and right when i signal left or right whiles braking the signal works but the other signal light sticks on with the brake light. so if any one as any idears please let me know thanks