Check that a door sensor isn't broken. When you are in the car and all the doors are closed and the car is on, check if the light on the dashboard that signals that a door is open is lit. If it is the sensor switch will need to be fixed on whichever door is broken.
On the second generation Clio, the interior light can be switched between the main light and a movable spotlight. Carefully moving the switch to between the two modes will turn off the interior light.
On a Renault Clio washed car but Rear indicator lights still on and can't turn them off?
You have to repair the part that caused the light to come on.
Get it serviced
inside the uch
I have an 05 Renault Clio and i can't seem to find how to even turn the side lights on?Any help?
Try disconnecting the battery for about 10 minutes - sometimes it works
CHECK YOUR GLOVE COMPARTMENT FOR A LOCK I HAVE ONE IN MINE AND HAVE NO IDEA WHAT ITS FOR
Hi how I can bypass or cut of immobilizer for renalt clio 1998 1.2 8v 59hp imobilaizers is in main block ecu
reset the lightFirst you press the odometer button then at the same time you put the key in "on" no engine running, wait for 30 secs aprox and it will be reset, repeat this steps for the oil light what is the odometer button
I had this problem on my clio 172, it's just the battery in the key fob may need replacing if the engine will turn over but just not start? works everytime for me now!
Turn the ignition on then disconnect the battery.hi to all Renault clio 2001 immoboliser probs light wont go of try this........ open your key now take out the green board now place the key in the ignition don't turn now place that green board back on its place and turn ur key and see if the light goes off if it don't try this for a few times it goes off,, contact me at poizen2005@yahoo.com tell me it it works
Turn the car off... Then turn the keys in the ignition until all the dash lights light up... Then turn you headlights on and off maually three times... You should hear a beep. that means you have disabled the sensor! :) Hope that helps... repeat the process to turn it back on! :)