answersLogoWhite

0


Best Answer

IT COLUD BE A RELAY BOX

multi function switch( turn signal, lites ect.)

User Avatar

Wiki User

โˆ™ 2011-01-09 23:22:13
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Your blinkers interior lights and brake light does not work Is it a fuse?
Write your answer...
Submit
Related questions

Your brake lights and head lights do not work your blinkers and running lights do?

My rear window brake light works, but not my tail light brakes on my 1997 Monte Carlo. What is the problem?


Why will the blinkers on an 81 K-10 pickup work but the brake lights will not?

Check the bulbs. These bulbs are a combination tail light & brake light. Even though the blinkers work, the brake light part might be burnt out. If these are okay, check the brake light switch. It's mounted on the brake pedal. Are the brake lights on all the time or they don't light up at all? if all the bulbs are fine, its more than likely the stop-light switch underneath the brake pedal.


Where is the sensor on the brake pedal I have no brake lights but the blinkers work and all fuses are good?

brake light switch is above the brake pedal under the dash


Why do interior lights go on when brake is applied?

There probably is only one cause for your interior lights to go on when you apply the brakes. There probably are brake light wires and interior wires that have warned together.


You have blinkers brake lights and flashers but your 1996 ford windstar has no tail lights why?

have you check the tail light fuse to see if it is blown. other possiblly is the headlight switch.


Would the brake light switch affect interior lights?

no it will not, because they're not connected with the same switch


Your brake lights dont light up when you pushe the brakes but the blinkers and everything else works on the tailights what is the problem?

Check the 30 amp brake fuse (green) in the engine compartment fuse block.


Why would a ford mustangs rear running lights and brake lights work but not the headlights and interior lights?

It sounds like a blown fuse or a bad head light switch


Brake lights don't work when the brake is pushed. Work with headlights on only.?

The brake lights and the tail lights are separate circuits. Check the brake light fuse, then check the brake light bulbs, then check the brake light switch.


What could cause left brake light and tail light to not work when brake pedal is depressed with head lights on while with head lights off brake lights and blinkers work ok on 1988 ford econoline van?

Answerpull the bulbs on the left and make sure they are not in with the tits in the wrong position. That is lower teet in the upper slot of the socket.


Where is the relay located that controls the tail lights and interior lights on a 2000 Mitsubishi Mirage?

The relay that controls the taillights and interior lights on a 2000 Mitsubishi Mirage is in the driver's side fuse box. It is to the left of the steering wheel in the dash. One thing to note about this vehicle is if a brake light burns out, the car might also lose the dash lights or interior lights. Check the brake lights before replacing a fuse that might not need replacing.


Does a car burn more gasoline when its lights are turned on?

head lights, dome lights, blinkers, any light.... ABSOLUTELY NOT!!


What causes the battery not to hold a charge on a 1997 F150?

Defective battery or something is pulling power from the battery. Check the glove box light, interior lights, trunk light, hood light, brake lights, etc.


Where is the dash light fuse on a 100 series landcruiser?

If you dash lights are not working check that your parking/brake lights are working also check fuses for cig lighter and interior lights that may help get the dash light working again.


What is wrong with a 1996 Toyota Camry if taillights do not work you have checked all the fuses and replaced the bulbs daytime running lights work blinkers work headlights work brake lights work?

GO AND BUY I NEW light bulb !


Eagle talon 1995 brake lights are not working But the lights work when the light are on why dont the brake lights come on?

it could be a plunger relay switch or pressure switch as some people call them. It will be mounted on the brake pedal arm. but i would check the bulbs first because if it is a dual filament bulb it could have gone out on one filament and not another. if your tail lights work and the blinkers work while the tail lights are on then most likely it is the switch on the pedal


What are all the lights on a school bus?

All the lights on a bus are: 4 way flashers (4) cation lights ( yellow ) 4 cation lights ( Red ) 4 strobe light (top of bus) (1) back up lights (2) brake lights (4) blinkers (4) head lights (low beams) (2) head lights (high beams) (2)


When a 1989 Toyota Camry has no tail lights but the brake lights license plate lights blinkers and the two side lights work what's wrong?

Check the tail light bulbs, clean it if you have using fine sandpaper. If it did no work check the cable connected to the lights. If the cable integriry was not damaged, check the fuse box.


1977 Ford F-350 Brake lights work but no blinkers When you turn a blinker on then they opposite side brake light goes off The flasher has been replaced The blinker lights on the dash don't come on eit?

Turn signal switch is melting...replace the turn signal switch in the steering column.


What is the warning light that looks like the brake lights are on on a 1999 Camry dashboard?

That warning light means a light bulb is out. Check all of your brake lights (including the brake light on the rear dash!)


How do you get brake light and third light working on a ford explorer?

Depending on the year, there may be one fuse for all three brake lights, or two fuses, one for the highmount brake light and one fuse for the two lower brake lights/tail lights. So, if all three brake lights are out, it could be just one fuse or perhaps the brake light switch which is on the brake pedal metal arm assembly.


What is wrong when 1 brake light is out but the tail light and other brake lights work good?

The bulb is burnt out. If the problem was a fuse, then all brake lights and probably the dashboard lights would be out as well.


What are interior lights?

Lights inside the car. Dome light, courtesy light, etc.


My brake lights wont work on my 93 ford explorer but when I turn my head lights on all the lights work just not the brakes?

The brake lights are an entirely separate system from the head/tail lights but have a lot in common with the blinkers and four way flashers. TO test the bulbs try the blinkers. If you get the same bright-red lamp that your brakes should use, your lamps are OK. Look under the dash at the top of the brake pedal. There is a switch on the pedal connected to two wires in a black jacket. That is the brake light switch. If you unplug the wires and read the voltage at the plug from pin to ground, one should have battery voltage. If there is no battery voltage then the fuse or the wiring between the fuse block and the switch is bad. If there is voltage, short across the two pins. This should light up your brake lights. If the brakes light, the switch is bad and needs to be replaced. If you you have voltage and don't get lights when you short the pins then your wiring between the brake pedal switch and the brake lamps is bad. You will probably need to involve a garage at that point.


Why do the interior lights light up inside a Volkswagen beetle?

Well they are interior lights. Usually lights light up (assuming there is power to them and they aren't burnt out.